Atlas fan company ALESSANDRA-LK Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wentylator Atlas fan company ALESSANDRA-LK. Atlas fan company ALESSANDRA-LK 15 stron. 42", 56" & 72" ceiling fan
Drukuj stronę
5. HANGING THE FAN
REMEMBER to turn off
steps below to hang your fan properly.
1. Remove the decorative canopy bottom cover
from the canopy by turning the cover counter
clockwise. (Fig. 5)
2. Remove the hanger bracket from the canopy by
removing the 1 of 2 screws from the bottom of the
hanger bracket and loosening the other one a half
turn from the screw head. Next, turn the canopy
counter clockwise to removing the hanger bracket
from the canopy. (Fig. 5)
3. Secure the hanger bracket to the ceiling outlet
box using screws and washers included with your
outlet box. (Fig. 6)
4. Remove hanger ball from down rod assembly by
loosening set screw, removing the cross pin and
sliding ball off rod. (Fig. 7)
5. Loosen the two set screws and remove the hitch
pin and lock pin from the central shaft/top coupling
of the motor assembly. Doing so will allow the
downrod to enter the central shaft. (Fig. 7)
6. Route wires and safety cable exiting from the
top of the fan motor through the coupling cover,
canopy cover and canopy and then through the
ball/ downrod. (Fig. 8)
7. Align the holes at the bottom of the downrod
with the holes in the collar on top of the motor
housing. Carefully insert the hitch pin through the
holes in the collar and downrod. Be careful not to
jam the pin against the wiring inside the downrod.
Insert the lock pin through the hole near the end of
the hitch pin until it snaps into its locked position.
(Fig. 8)
WARNING/CAUTION: Failure to properly install
lock pin as noted in step 7 could result in fan
loosening and possibly falling.
8. Tighten two set screws on top of the fan motor
firmly.
9. Carefully reinstall the hanger ball back onto the
downrod with cross pin and set screw. Place
downrod rubber cover onto the hanger ball. (Fig. 8)
the power. Follow the
UL Listed
electrical
box
Hanger bracket
Mounting screws
(supplied with
electrical box)
Hanger
ball
Safety cable
Downrod rubber
cover
Downrod
Coupling cover
Hitch pin
4
Ceiling
hanger
bracket
Ceiling
canopy
Canopy
cover
Figure 5
Tab
Figure 6
Cross pin
Set screw
Downrod
Figure 7
Supply wires
Hanger ball
Canopy
Canopy cover
Set screws
Lock pin
Figure 8