Anova CC251T Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kosiarka Anova CC251T. Anova CC251T 19 stron.

Anova CC251T Instrukcja obsługi
can also be beneficial for your lawn. When you mow the leaves, make sure they are dry and not too thick on
the lawn. Don't wait for all the leaves to be off the trees before cutting.
WARNING:If you hit a foreign object, stop the engine. Remove the spark plug wire, thoroughly inspect
the mower for any damage, and repair the damage before restarting and operating. Extensive mower
vibration during operation is an indication of damage. The unit must be promptly inspected and repaired.
7.6 GRASS COLLECTOR
There is a window on the rear deck. You can see the condition of the grass catcher through the window. If the
catcher is full of grass, it will empty and clean the bag, make sure it is clean and make sure its mesh is vented.
Figure 11
Fig.11
7.7 COVER
The underside of the mower deck should be cleaned after each use to prevent the buildup of grass clippings,
leaves, dirt, or other debris. If these residues are allowed to accumulate, they will invite rust and corrosion,
and may prevent proper mulching. The deck can be cleaned by tilting the mower and scraping with a suitable
tool (make sure the spark plug wire is disconnected).
7.8 INSTRUCTIONS FOR HEIGHT ADJUSTMENT
CAUTION:Do not at any time make any adjustments to the mower without first stopping the engine and
disconnecting the spark plug wire.
CAUTION:Before changing cutting height, stop mower and disconnect spark plug wire.
Your mower is equipped with a center height adjustment lever that offers 10
Height (blade to ground) can be adjusted from 25mm to 75mm (10 height positions).
1. Stop the mower and disconnect the spark plug wire before changing the mower's cutting height.
2. The central height adjustment lever offers you 10 different height positions.
To change the height of the rear wheel, squeeze the adjustment lever towards the wheel, moving it up or
down to the selected height.
Fig.12
14
positions.(Fig.12)