ANP Lighting Madison Instrukcje instalacji

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Oprawa oświetleniowa ANP Lighting Madison. ANP Lighting Madison 2 stron. Arm/wall mount

Drukuj stronę
INNOVATIVE SITE LIGHTING
IMPORTANT
Standard 4/0 Junction Box
(by others)
Screws (C)
Nipple (A)
Backplate Support
Grommet (D)
Wall Mount
Back Plate Support (A)
Standard
4/0 Box
by others
© 2016 ANP Lighting. All rights reserved. These specifications are intended for general purposes only.
ANP reserves the right to change material or design, without prior notice, in a continuing effort to upgrade its products.
MADISON ARM / WALL MOUNT INSTALLATION INSTRUCTIONS
Safety, Warning and Suggestions
1. Qualified electrician is required to install this product/s.
2. Please read instructions carefully before installation.
Strap (B)
Knurled Cap Nut (E)
Mounting Hardware (H)
Screws (C)
Back Plate (B)
Screws (C)
3. All wiring and installations should meet local, state and national electrical codes.
4. Install correct lamp type and wattage.
1.
Prior to installation, disconnect power
at main electrical box.
2.
Thread nipple (A) into strap (B) as shown,
allowing approximately 3/4" below strap.
3.
Attach strap (B) to junction box using
screws (C).
Backplate (G)
4.
Bring J-box wiring, including ground wire,
through either grommet in back plate sup-
port (D).
5.
Slip back plate support over nipple and
attach with knurled cap nut (E) provided.
Arm (F)
6.
Verify that lead wires from shade are long
enough for arm (F) provided.
7.
Feed lead wires through arm and thread
shade onto arm.
8.
Place arm into back plate (G) and tight-
en set screws (H). Use Loctite for most
secure connection.
9.
Make wiring connections.
10.
Slip back plate over back plate support
and attach using mounting hardware (I)
provided.
1.
Prior to installation, disconnect power
at main electrical box.
2.
Bring J-box wiring, including ground wire,
through back plate support (A) and attach
to junction box.
3.
If required, lag back support plate to wall
with hardware by others.
4.
Make wiring connections.
5.
Place back plate (B) over back plate sup-
port and tighten screws (C). Use Loctite
for most secure connection.
1-800-548-3227
ANPlighting.com