DS Produkte DY16023-0000 Instrukcje - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje dla Sprzęt oświetleniowy DS Produkte DY16023-0000. DS Produkte DY16023-0000 4 stron. Led wc light with changing colours
EN
Dear Customer,
We are delighted that you have chosen this LED WC light
with changing colours. If you have any questions, contact the
customer service department via our website:
www.service-shopping.de
Intended Use
•
The article is intended to be used on all customary toilets.
•
The article is designed for personal use only and is not intended
for commercial applications.
•
Use the article only as described in the instructions. Any other
use is deemed to be improper.
•
The following are excluded from the warranty: all defects
caused by improper handling or damage. This also applies to
normal wear and tear.
Safety Instructions
■
Danger of suffocation! Keep the article and the packaging
material away from children and animals.
■
This article is not a toy!
■
Batteries can be deadly if swallowed. Therefore keep
batteries and the article out of the reach of children and animals.
If a battery is swallowed, seek medical assistance immediately.
■
Before inserting the batteries, check whether the contacts in
the battery compartment and on the batteries are clean; clean
them if necessary.
■
Use only the battery type specifi ed in the technical data (see
the "Technical Data" section).
■
Always replace all the batteries at the same time. Do not
use batteries of different types or brands, or batteries with
different capacities. When replacing batteries, note the correct
polarity (+/–).
■
Take the batteries out of the battery compartment when they are
discharged or if the article is not being used. This will prevent
any damage that might occur if a battery leaks.
■
Should a battery have leaked, do not allow your skin, eyes and
mucous membranes to come into contact with the battery acid.
If you touch battery acid, rinse the affected sites with abundant
fresh water immediately and contact a doctor as soon as
possible.
■
Remove a leaking battery from the battery compartment
immediately. Clean the contacts before you insert a new battery.
■
Children must be supervised in order to ensure that they do not
play with the article.
■
The article should only be used in closed rooms.
■
Do not expose the article to extreme temperatures, direct
sunlight or strongly fl uctuating temperatures.
■
Do not drop the article or subject it to severe impact.
■
Maintain a suffi cient distance from candles, fi replaces, hobs, or
other sources of fi re and heat.
■
Ensure that the housing cannot fall into water or become wet.
To clean the article, wipe the housing with a soft, dry cloth.
More intense soiling can be wiped off with a slightly damp cloth.
■
Keep the article out of the reach of children and animals in a
dry, clean place that is protected from direct sunlight.
■
If the article is broken, do not attempt to repair it yourself. In the
event of any damage, contact our customer service department.
Items Supplied
•
1 x LED WC light
You also require 3 x 1.5 V batteries, AAA type. These are not
supplied with the article.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
Instructions
Putting Into Operation
The motion sensor only works in a dark environment.
1. Unpack all the parts. Check the items supplied for possible
transport damage. If you should fi nd any transport damage,
do not use the article(!), but contact the customer service
department immediately.
2. Open the battery compartment on the back of the housing by
pressing down the locking lug and fl ipping open the battery
compartment.
3. Insert 3 x 1.5 V batteries, AAA type into the battery compartment.
Pay attention to the correct polarity (+/–).
4. Fit the battery compartment cover again and press it down until
it engages audibly.
5. Set the colour mode you want by repeatedly pressing the
button on the front of the housing. The article is preset to colour
change. You can select each of the 7 colours as a constant light
or switch back to colour change.
6. Adjust the brightness of the light by holding down the colour
selection button for 3 seconds. The light fl ashes once. You can
now adjust the brightness in 5 levels by pressing the button
again.
7. Attach the article to a suitable place under the toilet seat using
the fl exible suspension device. When you do this, make sure:
– that the housing is hanging on the outside. Only the
suspension device with the light may hang in the toilet bowl.
– that the motion sensor is not hanging at the back of the toilet
so that it can detect movements.
8. If the motion sensor detects a movement, the LED light is
automatically switched on.
9. The LED light switches off automatically after 25 seconds when
the motion sensor does not detect any more movement.
If the performance of the article diminishes, the batteries should
be replaced. The article indicates a weak battery each time it is
switched on by fl ashing 5 times.
Technical Data
Article number:
Model number:
Voltage supply:
Disposal
Dispose of the packaging material in an environmentally
friendly manner. It is reusable. Take it to a recycling centre.
Dispose of the article in an environmentally friendly
manner. It should not be disposed of in the normal
household waste. Please dispose of it at a recycling centre
for used electrical and electronic devices. You can obtain
more information from your local authorities.
Non-rechargeable and rechargeable batteries should
be removed before the article is disposed of and should
be disposed of separately from the article. To protect
the environment, non-rechargeable and rechargeable
batteries may not be disposed of with normal household
waste, but must be taken to suitable collection points.
Also note the relevant statutory regulations governing the
disposal of batteries.
Customer Service / Importer:
All rights reserved.
Article number: 00033
00033
DY16023-00000
4.5 V DC (3x 1.5 V battery, type AAA)
✆
+49 38851 314650 *)
Z 00033 M DS V1 0716