DSC PC510 Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa DSC PC510. DSC PC510 20 stron.

Drukuj stronę

INSTALLATION

Mounting the Panel

Select a dry location close to an unswitched AC source and a ground connection.

Remove the printed circuit board, mounting hardware and keypad from the cardboard retainer inside the

control panel cabinet. Before attaching the cabinet to the wall, press the four white nylon printed circuit board

mounting studs into the raised mounting holes from the back of the cabinet. Also, secure the ground screw to

a hole in the cabinet.

Hold the cabinet in position and pull all wires into the cabinet. Mount the cabinet securely to the wall using the

mounting screws provided. It is recommended that appropriate wall anchors be used when securing the panel

cabinet to drywall, plaster, concrete, brick or other similar surfaces.

Press the PC510 Control Panel onto the nylon mounting studs. Pull all cables into the cabinet and prepare them

for connection.

Mounting the Keypad

The PC510 Control Panel is controlled by the SL-40 or PC500RK Keypad. The Keypad should be located close

to the designated "Entry-Exit" door and mounted at a height convenient for all users.

Refer to the illustrations for the keypad included with your control panel. Disassemble the keypad by pressing

gently on the locking tab found on the bottom of the unit. With the tab disengaged, pull the backplate from

the keypad.

Prepare a hole in the wall at the desired location and pull the keypad wiring through the hole. Hold the backplate

in position and pull the wires through the large opening in the backplate. Mount the backplate to the wall using

the hardware provided; it is recommended that plastic wall anchors be used. When mounting the backplate,

ensure that it is straight and level.

Prepare all wires for connection and connect the keypad wires to the in-wall wiring; refer to the Wiring Diagram

in the back of this manual.

Align the keypad with the mounting tabs on the top of the backplate. With the top mounting tabs engaged, swing

the keypad down and engage the bottom locking tab. Ensure that the top mounting tabs and the bottom locking

tab are securely engaged.

SL-40 Keypad

SL-40 KEYPAD

BOTTOM VIEW

ENGAGE TOP TABS FIRST

WALL

LOCKING TAB

RE-ASSEMBLY OF

SL-40 KEYPAD

SIDE VIEW

(WIRES NOT SHOWN

FOR CLARITY)

SWING KEYPAD DOWN

TO ENGAGE LOCKING TAB

firealarmresources.com

PC500RK Keypad

Ready

Armed

System

Zone 1

Zone 2

Zone 3

Zone 4

PC500RK KEYPAD