DSC MAXSYS PC4850 Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Jednostka sterująca DSC MAXSYS PC4850. DSC MAXSYS PC4850 16 stron. Telephone entry module

2.12 Connecting the PC4850 to Ground

Make a ground connection as shown below:

Once all other wiring is complete, power up the PC4850:

• After powering up the PC4850 for the first time, wait

for 10 seconds and then remove the shorting jumper J2.

During the normal operation of the PC4850, the

jumper must be kept removed.

• Connect the main board transformer to terminals AC1

and AC2, as shown.

• If connecting a backup battery, connect the red battery

lead to the +BAT terminal and the black lead to -BAT.

-BAT +BAT

12V

DC Backup

Supply

Use AWG #18

There is a lithium battery on the module. Do not attempt

to replace this battery. There is a danger of explosion if

the battery is incorrectly replaced.

If the lithium battery stops working, return the circuit

board to the supplier. Batteries may cause a fire when in

contact with metal. If you need to dispose of the circuit

board and/or the lithium battery, wrap the battery in

non-conductive tape. Check with your local government

for battery disposal regulations.

WARNING: Do not store the batteries in such a way

that they come into contact with each other or with

any piece of metal. Explosion or fire may occur. Should

fire occur, use only dry chemical fire extinguishers. Do

not use water to put out the fire.

Do not heat the batteries. Do not dispose of the batter-

ies or circuit boards in a fire. Do not disassemble the

batteries. Do not apply pressure to or deform the bat-

teries. Ensure that the above precautions are strictly

observed by related departments, including, but not

limited to, production, sales and outside contractors.

Please see diagram below for connecting tamper.

Normally Closed

GND

Contact