AIRTUG TT-HD-EM-8 Instrukcja montażu i obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja montażu i obsługi dla Sprzęt rolniczy AIRTUG TT-HD-EM-8. AIRTUG TT-HD-EM-8 5 stron. Trailer tugs

www.airtug.com

Loading: Position the ball of the tug under the receiver of the trailer and stop. Then either crank the

trailer down onto the tug (Manual) or push the button to raise the ball up into the receiver and lift the

tongue of the trailer up into the air (Automatic). Do not hold the button when the cylinder is maxed

out on stroke. This can cause damage to the cylinder motor and electronic circuits.

Operating Instructions

Step 1: Prior to the ﬁrst use, plug the

charger cable into a 110V outlet or

extension cord and charge the batteries

fully as indicated by the green light at the

top of the charger. The orange light

indicates batteries are charging. Keep the

battery charger plugged in between use.

See the battery charger manual for more

information.

Step 2: Plug in the trailer electric to the

plug on the tug labeled "Surge Brake By-

Pass" and this will not allow the surge

brakes to lock up when pushing the trailer in reverse.

Step 3: Turn switch at end of handle to the "On"

position. Select "FWD" or "REV" and slowly press

the thumb throttle to slowly begin movement of the

tug. Begin movement as slowly as possible to

initiate momentum.

General Maintenance

Tire Pressure:

The tire pressure can range from

30 psi for lighter trailers to the maximum tire pressure of 70 psi for heavier trailers. It should be

reduced for added traction for lighter trailers. Lower pressures improve traction.

Batteries:

Keep the batteries fully charged. The battery performance will diminish measurably as

the ambient air temperature drops.

Transaxle:

This is a sealed unit and should not require maintenance or ﬂuid.

Drive Wheel Bearings:

Permanently lubricated.

Caster Zerk Fittings:

Needs to be lubed periodically to ensure ease of caster wheel steering.