Anywire ARW-03 Instrukcja obsługi produktu - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Napęd Blu-ray Anywire ARW-03. Anywire ARW-03 17 stron. Address writer
Również dla Anywire ARW-03: Instrukcja obsługi systemu (6 strony)
Drukuj stronę[Direct writing of parameters]
The values become available at the time when addresses are written.
Check that power (in the case of 2-wire type, transmission signal) is supplied to the target unit in writing addresses.
In this mode, the values are updated at the time when addresses are written. Please carry out the operation
carefully because the characteristics and movement change and it may result in unexpected operation.
■Parameter direct writing operation
How to operate
1
Turn ON the POWER switch.
2
Press the SELECT switch.
Press the SELECT switch several
3
times to light the DIRECT WRITE
display.
Press the SET switch.
4
Press the UP switch once to change
5
the display to parameter writing.
6
Press the SET switch.
Display the parameter value to be
written by using the UP/DOWN switches.
Point the light emitting and receiving
part (yellow frame) at the address
setting port of the unit to be written
and then press the SET switch.
7
In the case of failure in writing
Readjust the light emitting and
receiving part and
8
press the SET switch again.
If writing parameters from another
9
unit, return back to Operation
No.6 to repeat the operations.
- Clear the Err display.
- Switch the mode to another mode.
10
Press the CLEAR switch.
11
Press the L switch.
If returning to the address setting mode,
12
press the DOWN switch once.
After using ARW-03, keep the POWER switch
pressed to turn OFF the power.
DIRECT WRITE (orange)
Example)
Example)
Example)
WRITE must be lighted.
-ARW03 15/17-
Display
After approximately
2 seconds, "SELECt" flashes.
Flashing
The writing mode is
determined.
Dot flashing movement
In the case of selecting
variable "1" in parameter 1
During the writing operation
Written parameter values
Err display
During the writing operation
Written parameter values
Return to the writing
mode display
Dot flashing movement
Change to the Ad display.
Light emitting and
receiving part
(yellow frame)