Audiovox Keyless Entry Alarm Upgrade Module APS-30 Instrukcja instalacji
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Alarm samochodowy Audiovox Keyless Entry Alarm Upgrade Module APS-30. Audiovox Keyless Entry Alarm Upgrade Module APS-30 6 stron. Audiovox keyless entry alarm upgrade module installation instructions
Drukuj stronę
KEYLESS ENTRY ALARM UPGRADE MODULE
PRE - INSTALLATION NOTES :
This system provides an output that should be used to drive the siren, but can be programmed to pulse the vehicle's horn.
When utilizing the horn, an additional relay is required. Caution: on many vehicles the factory horn is not designed
for continuous use, and it is recommended that the siren is used for these vehicles. Check to see if the horn in the vehicle
is the same part that is used in a vehicle with the factory installed security system.
When installing the APS-30 as a stand alone passive alarm system, the dip switches must be set as follows;
This alarm can be programmed to operate as either a " PASSIVE " or " ACTIVE " arming security system.
As a passive arming system, the alarm will automatically arm 30 seconds after the ignition key is turned off, one door is opened, then
all doors are closed. Additionally, if a door has been left opened, or if one of the trigger zones is defective, the system will always arm
10 minutes after the ignition key has been turned off, and ignore the defective trigger zone.
As an active arming system, the alarm will arm only when the vehicle's doors have been locked using the existing OEM Keyless Entry
Transmitter.
The system is shipped from the factory in the active arming mode, and to select the passive arming mode, move dip switch # 1 to the "
ON " position.
This alarm can be programmed for either 1 wire or 2 wire disarm operation.
Many OEM keyless entry systems use on - board door unlock relays, which usually results in the ability to disarm the aftermarket security
upgrademodule by unlockingthe doorsusingthe door panelunlockswitch.Wiringthesystemfor 2wiredisarmwilleliminate thisproblem.
The system is shipped from the factory in the 2 wire disarm mode, and to select the 1 wire disarm mode, move dip switch # 2 to the "
ON " position.
INSTALLATION INSTRUCTIONS
STAND ALONE PASSIVE ALARM
Dip Switch # 1 = ON
Dip Switch # 2 = ON
Dip Switch # 3 = OFF
Dip Switch # 4 = OFF
Dip Switch # 5 = OFF
Dip Switch # 6 = OFF
DIP SWITCH SETTINGS
ON
PASSIVE ARMING
1
2
1 WIRE DISARM
3
HORN MODE
INSTANT TRIGGER
4
- ARM INPUT
5
6
VOLTAGE SENSE
PASSIVE / ACTIVE ARMING SELECTION : DIP SWITCH # 1
1 OR 2 WIRE DISARM INPUT SELECTION : DIP SWITCH # 2
HORN OR SIREN OUTPUT SELECTION : DIP SWITCH # 3
Model APS-30
OFF
ACTIVE ARMING
2 WIRE DISARM
SIREN MODE
ENTRY DELAY
+ ARM INPUT
HARDWIRE