Audiovox 1181292 Instrukcja instalacji - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Samochodowy system wideo Audiovox 1181292. Audiovox 1181292 12 stron. Overhead console for use with flipdown video system chevrolet suburban
Drukuj stronę
Caution: Do not overtighten screws. Use extra support for the console until secured to the vehicle.
Failure to do so may cause damage to console or installed components.
2. Raise overhead console into approximate position and
connect wiring to O.E. components.
3. Loosely fit console against headliner. Check that
console is centered in vehicle and matches all contours
of headliner. While supporting console in mounting
position, loosely install using two (2) 6-32 X 3/4"
screws (item 10 pg 2) through the smaller holes in
bracket on console into threaded clips on mounting
bracket. See Figure 17.
Figure 18
IV. INSTALLATION OF OVERHEAD CONSOLE.
Figure 16
1. Construct a jumper harness that will connect
the vehicle's dome light wires to the lights in
the console and video system. Connect the
white wires from lights to the O.E. white
wire. Connect the black wires from lights to
the O.E. orange wires. Do not use O.E.
black wire. See Figure 16.
4. Secure front of console using two (2 ) # 8 X 1
1/4" PWH screws (item 3 pg 2) in front of
console. See Figure 17. Caution: Do not
overtighten screws or damage to vehicle roof
may occur.
5. Open sunglass holder on O.E. console. Install
two ( 2 ) # 8 x 1 1/4" PWH screws (item 3 pg
2) in dimple area. See Figure. 17. Caution: Do
not overtighten screws or damage to vehicle
roof may occur.
6. Tighten 6-32 X 3/4" screws previously
installed in step 3.
11
Figure 17