APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER Instrukcja obsługi i instrukcje konfiguracji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje konfiguracji dla Crossover APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER. APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER 9 stron.
Drukuj stronęFULL RANGE APOGEE/SCINTILLA ACTIVE CROSSOVER
Setting the crossover networks and two-way or three-way operation will be performed
at the factory if the system configuration is specified in advance of purchasing
the crossover.
If it is desired to perform the changes in the field then this may simply be
accomplished by setting the rocker switches.
The active crossover rocker switches are located inside the active crossover.
To set the rocker switches the following procedure should be followed.
a. Unplug the active crossover power plug.
b. Unscrew the top plate.
c. For the two-way operation push the top rocker switches C1 and C3.
(See Figure.1)
For three-way operation push the top rocker switches C2 and C4.
d. Large Full Range Apogee frequency shaping network insertion requires pushing
the bottom rocker panel switches C1 and C3.
e. Scintilla two-way operation and frequency shaping network insertion requires:
1. Top Rocker Switch – push C1 and C3.
2. Bottom Rocker Switch – push C2 and C4.
Top Rocker Switches
C1
C2
Bottom Rocker Switches
C1
C2
FIGURE 1
C1 and C3 pushed = 2 way
C3
C2 and C4 pushed = 3 way
C4
C3
C1 and C3 pushed = Large Full
Range Apogee
C2 and C4 pushed = Scintilla
C4
(Page 2)