Abus SHRM10000 Oryginalna instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Oryginalna instrukcja obsługi dla Alarm dymowy Abus SHRM10000. Abus SHRM10000 16 stron. Z-wave smoke detector

5.4.

Reset (Factory-Reset)

5.5

Battery change

6.1.

Z-Wave devices can control other devices directly. This direct control is called in Z-

Wave association. For this purpose, the device ID of the device to be controlled must

be stored in the controlling devices. This is done in so-called association groups. An

association group is always linked to an event in the controlling device (pressing a key

or triggering a sensor). When this event occurs, a control command - usually a BASIC

SET - is sent to all devices stored in an association group.

The smoke detector supports the following association groups:

1. Remove the battery

2. Press the Network button and keep it

pressed while inserting the battery again.

Device will restore factory settings

Note:

1, This procedure should only be used if the

primary gateway is not capable of acting.

2, If the multi-sensor is set to the factory

setting, the status is set to "not included", the

association

settings

configurations are reset to default.

1. Turn the device anticlockwise and

remove it from the mounting bracket and

remove the old battery

2. Insert a new battery, ensure that the

polarity is correct

3. Test the smoke alarm device. To do so,

press and release the test button. The

alarm will sound loud short beeps

indicating that the smoke detector works

normally

Turn the detector back onto the bracket

English

and

possible