Apollo XPander Instrukcja uruchomienia - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja uruchomienia dla Czujniki bezpieczeństwa Apollo XPander. Apollo XPander 19 stron. Diversity loop interface module
Introduction
XPander incorporates entirely new designs with respect to the wireless communication system. A Radio Interface
is connected to the loop. It communicates with the control panel using the Apollo Addressable two-wire power
and communications system. The interface communicates with the detection and alarm signalling devices by
means of radio waves. A maximum of 5 interfaces is permitted for each site. For sites that require more than 5
interfaces please contact Apollo.
The radio bases and signalling devices are addressable and use a pre-set analogue value to report via the Apollo
protocol. Apart from normal and fire the bases can send pre-set analogue values to indicate low battery, detector
contaminated, detector tamper and low signal strength fault conditions.
•
Up to 5 interfaces per site - contact Apollo for more information
•
Up to 31 devices per interface
•
Loop-powered interface (Including bi-directional Short Circuit Isolator)
•
Wireless addresses seen by control panel as normal addresses
•
Radio base with wireless circuitry and battery compartment
•
Optical chamber designed to inhibit dirt penetration and thus reduce false alarms
•
Automatic drift compensation with DirtAlert™ warning
•
Detection algorithms for transient rejection
•
FasTest™ reduces time taken to test detectors
•
Remote test facility
•
5-year battery life (It is recommended that the battery is changed in year 4 of maintenance)
•
Alkaline Panasonic® Powerline or Alkaline Varta® Industrial are the recommended battery types to use
•
Modern styling
© Apollo Fire Detectors Limited 2015
3