Apollo Xpander XPA-CB-14022-APO Instrukcja uruchomienia - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja uruchomienia dla Czujniki bezpieczeństwa Apollo Xpander XPA-CB-14022-APO. Apollo Xpander XPA-CB-14022-APO 19 stron. Diversity loop interface module
Również dla Apollo Xpander XPA-CB-14022-APO: Instrukcja uruchomienia (14 strony)
Drukuj stronę
Introduction
XPander incorporates entirely new designs with respect to the wireless communication system. A Radio Interface
is connected to the loop. It communicates with the control panel using the Apollo Addressable two-wire power
and communications system. The interface communicates with the detection and alarm signalling devices by
means of radio waves. A maximum of 5 interfaces is permitted for each site. For sites that require more than 5
interfaces please contact Apollo.
The radio bases and signalling devices are addressable and use a pre-set analogue value to report via the Apollo
protocol. Apart from normal and fire the bases can send pre-set analogue values to indicate low battery, detector
contaminated, detector tamper and low signal strength fault conditions.
•
Up to 5 interfaces per site - contact Apollo for more information
•
Up to 31 devices per interface
•
Loop-powered interface (Including bi-directional Short Circuit Isolator)
•
Wireless addresses seen by control panel as normal addresses
•
Radio base with wireless circuitry and battery compartment
•
Optical chamber designed to inhibit dirt penetration and thus reduce false alarms
•
Automatic drift compensation with DirtAlert™ warning
•
Detection algorithms for transient rejection
•
FasTest™ reduces time taken to test detectors
•
Remote test facility
•
5-year battery life (It is recommended that the battery is changed in year 4 of maintenance)
•
Alkaline Panasonic® Powerline or Alkaline Varta® Industrial are the recommended battery types to use
•
Modern styling
© Apollo Fire Detectors Limited 2015
3