Apollo Spas Saturn Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wanna z hydromasażem Apollo Spas Saturn. Apollo Spas Saturn 20 stron.

3. Turn on the power.
Engage the breaker at the main panel, and then the GFCI sub panel and other switching devices installed by your
electrician. If wired correctly, the control panel will blink, showing the current water temperate. At this time you
should also see water movement through jets, if not you may have an air lock in the pump. The quickest way to rid
an air lock is to turn power off, then locate pump one and loosen the top union to let the air bleed out. When you
see a steady stream of water retighten the union and turn power back on.
4. Activate the jets.
Ensure all jet faces are in the full "open" position (clockwise). Set all the Venturi valves to the "open" position to
more clearly see water coming from all the jets. Press the PUMP 1 button to engage the lowest speed. While the low
speed is running slowly, locate the filter canister, and remove the black circular cover and locate the "Air Vent
Bleeder" inside. Turn the "Air Vent Bleeder" until you hear air movement. Once the air is escaping, stop
unscrewing until the water bleeds out for a few seconds. Then, slowly and gently screw the "Air Vent Bleeder" back
down until the water stops coming from the valve. Press the PUMP 1 and PUMP 2 buttons (if equipped). You
should see and be able to feel water coming from all of the jets. This will show that there isn't any air trapped within
the system. If water is not exiting from the jets, see the troubleshooting section of this guide or call your Apollo
Spas outlet.
5. Add the Start-Up Chemicals
Add the spa chemicals as directed by your Apollo Spas salesperson, as per the instructions within this manual,
or after reading the chemical supply bottles in your Start-Up kit.
6. Set the Temperature.
Your spa has a standard temperature range of 59-104
buttons on your spa side control. Simply press and hold the button until the correct setting is reached and release.
See the Quick Reference Card (QRC) provided with your spa for specific controller information.
7. Set the Filtration.
Please refer to the Quick Reference Card (QRC) provided with your spa for assistance in setting the filtration.
8. Install the Hardcover.
Place the cover on your spa, ensuring that it sits squarely around the corners. Position the locking straps on the
cabinet walls and attach them with the screws that have been supplied. Allow some slack in the tie downs for
shrinkage in cold weather.
F. You may adjust these settings using the UP or DOWN
°
9