Aponorm Basis Control Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor ciśnienia krwi Aponorm Basis Control. Aponorm Basis Control 19 stron.

Drukuj stronę

9. Error Messages

If an error occurs during the measurement, the

measurement is interrupted and an error message,

e.g. «ERR 3», is displayed.

Error

Designa-

tion

"ERR 1" Signal

too weak

"ERR 2"

Error

signal

No pres-

"ERR 3"

sure in the

cuff

Potential cause

and remedy

The pulse signals on

the cuff are too weak.

Re-position the cuff and

repeat the measurement.*

During the measurement,

error signals were de-

tected by the cuff, caused

for instance by movement

or muscle tension.Repeat

the measurement, keeping

your arm still.

An adequate pressure

cannot be generated in

the cuff. A leak may have

occurred. Check that the

cuff is correctly connected

and is not too loose.

Replace the batteries if

necessary. Repeat the

measurement.

Error

Designa-

tion

Abnormal

"ERR 5"

result

Pulse or

cuff pres-

"HI"

sure too

high

Pulse too

"LO"

low

* Please consult your doctor, if this or any other

problem occurs repeatedly.



If you think the results are unusual, please

read through the information in «Section 1.»

carefully.

Potential cause

and remedy

The measuring signals

are inaccurate and no

result can therefore be

displayed. Read through

the checklist for perform-

ing reliable measurements

and then repeat the

measurement.*

The pressure in the cuff

is too high (over 300

mmHg) OR the pulse is

too high (over 200 beats

per minute). Relax for 5

minutes and repeat the

measurement.*

The pulse is too low (less

than 40 beats per minute).

Repeat the measure-

ment.*

aponorm