Aponorm BASIS PLUS BLUETOOTH Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor ciśnienia krwi Aponorm BASIS PLUS BLUETOOTH. Aponorm BASIS PLUS BLUETOOTH 19 stron.

Clearing all values

If you are sure that you want to permanently re-
move all stored values, hold down the M button
(the monitor must have been switched off before-
hand) until «CL ALL» («CL ALL» = Clear All) appears
and then release the button. To permanently clear
the memory, press the M button while «CL ALL» is
flashing.
Aborting the deletion:
Simply press the On/off button
while «CL ALL» is flashing to abort the
deletion.
I t is not possible to clear individual readings.
5. Battery indicator and battery
change

Batteries almost flat

When the batteries are approximately 3/4 empty,
the partly filled battery symbol
as the device is switched on. Although the monitor
will continue to measure reliably, you should obtain
replacement batteries.
Batteries flat - replacement
When the batteries are flat, the empty battery sym-
bol
will flash as soon as the device is switched
16
on. You cannot take any further measurements and
must replace the batteries.
again
1
will flash as soon
16
In the event of a battery change or power
failure, the memory retains all values mea-
sured; the date and time must, however, be
reset. This is indicated by the year indicator
flashing.
For changing the batteries and resetting the date/
time please follow the instructions in Section 1 on
page 6.

Which batteries and which procedure?

Please use 4 new, long-life 1.5 V, size AA
alkaline batteries.
Do not use batteries beyond their date of
expiry.
If the monitor is not going to be used for a
prolonged period of time, the batteries must
be removed.

Using rechargeable batteries

You can also operate this monitor with recharge-
able batteries.
O nly use «NiMH» type reusable batteries.
W hen the flat battery symbol appears,
remove the batteries and recharge them.
They must not remain in the monitor as they
may become destroyed (exhaustive discharge
due to low consumption of the monitor even
when switched off).
11