Dusty Strings P10 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do instrumentów muzycznych Dusty Strings P10. Dusty Strings P10 7 stron. Dusty harp pickup for 24-30 string lever harps
Step 4: Mark Harness Clip Locations
If you have a Dusty Strings double-strung harp with circular holes drilled in the body braces, see page 7 and follow steps 4A-
6A instead.
1. or Dusty Strings FH26, Allegro or Ravenna 26: Mark an 'X' on the soundboard lining approximately 1" toward
F
the base of the harp from each element location (see figure 4, previous page). This location is approximate, and can be
adjusted as needed.
2.
For non-Dusty harps:
particular harp. Just make sure the main harness can stay relatively straight, the clips are not stuck to the soundboard
or positioned close enough to buzz against the soundboard or other parts of the harp, and you're not placing the har-
ness so far from the elements that it creates stress on the lead wires.
3.
Carefully remove the template from inside the harp.
4.
You should now have 3 clearly visible pencil dots on the soundboard and corresponding 'X' marks for the harness
clips on the lining.
Step 5: Attach Harness Clips
Note: Please read this section completely before attaching clips.
1.
Place a paperclip or thin coin on the soundboard under the
lowest 'X' mark on the soundboard lining to act as a spacer.
This is to prevent the harness clip from touching the sound-
board and causing unwanted vibration.
2.
Remove the paper backing from the self-adhesive patch on
one of the harness clips.
3.
Use the spacer to position the bottom edge of the clip up off
the soundboard (see figure 6).
4.
Firmly press the clip into place over the 'X' on the soundboard
lining, keeping it as square to the soundboard as possible. The
clip may be wider than the lining, and this is okay.
5.
Remove the spacer.
6.
Repeat for the remaining clips.
Step 6: Attach Pickup Harness
1.
Slide the pickup harness up through the bottom sound hole, being careful to avoid dragging or bumping the jack
against the harp.
2.
Orient the harness so the pickup element lead wires point toward the string rib, away from the side of the harp
figure 7 on next page).
3.
Slide the rubber grommets on the harness so that they align with the clips while allowing the pickup elements to line
up with the marks on the soundboard.
4.
Press the rubber grommets into the clips. The groove in each grommet should snap into place in the arms of the clip.
It is not necessary to twist the clips' "ears" together.
You will need to use your judgement to place the clips in locations that make sense for that
Soundboard
Figure 6 – Example spacers
4
Soundboard
lining
Spacers
(see