AUSSIE TONNEAU ATB01144 Instrukcja montażu

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Akcesoria samochodowe AUSSIE TONNEAU ATB01144. AUSSIE TONNEAU ATB01144 3 stron.

TONNEAU COVER FITTING INSTRUCTION

Volkswagen Amarok Dual Cab

1. TONNEAU COVER FITTING

NOTE: Read entire instructions prior to start.

1.1 BASIC TOOL REQUIRED

Drill, 4mm Drill Bit, Tape Measure, Rivet Gun, Marking Pencil / Pen, Clear Silicone / Silicone Gun

1.2 CONTENTS

1 x Tonneau cover

2 x Bar Brackets

18 x Buttons

1.3 TONNEAU COVER INSTALLATION PROCEDURE

1. Using two pieces of dowel, join the 2 aluminium rope tracks together. Place the other 2 pieces

of dowel in the ends of the now joined rope track.

2. Rest the aluminium rope track on the side rails as Shown in Diagram A, and push forward to

the vertical face of the tub.

3. Using a 4.5 mm drill bit, drill 6 holes 50mm from the end of each of the aluminium rope tracks

into the front of tub.

4. Once all the holes have been drilled, remove the dowelling pieces. Squeeze silicon along the

back of the rope tracks and pop rivet into place.

5. To fit bar brackets measure 735mm back from the inside front edge at the top of the tub and

place them as shown in Diagram A. (10mm down from top edge of tub). Drill and rivet using

two large rivets for each Bar Bracket. Install support bar according to supplied instructions.

6. To fit round body hooks to the tailgate, measure 475mm up from the bottom of the tail gate

and line up each hook individually to each bunji loop starting with the two either side of the

tailgate handle and working your way out.. Drill and rivet buttons alternating from side to side.

7. To fit round body hooks to the sides of the ute, measure 165mm down from the inside edge

and line up each hook individually to each bunji loop starting with the two bunjis at the rear

corners and working your way around to the front, drill and rivet buttons alternating from side

to side. For the front buttons' distance are 30mm from the edge of front tub. Diagram B

Without Sport Bar

2011 – Current

Part Number: ATB01144

2 x Aluminium rope track (780mm)

1 x Tonneau support bar

34 x Rivets

4 x Pieces of dowel