GREAT PLANES Fokker D.VII ARF ElectriFly Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES Fokker D.VII ARF ElectriFly. GREAT PLANES Fokker D.VII ARF ElectriFly 20 stron.
Drukuj stronę
PREPARATIONS
❏
1. If you have not done so already, remove the major
parts of the kit from the box (wing, fuselage, tail parts, etc.)
and inspect them for damage. If any parts are damaged or
missing, contact Product Support at the address or
telephone number on page 5.
❏
2. Separate the ailerons from the wing, the rudder from
the fin and the elevator from the stabilizer. If necessary, use
a covering iron set on medium/high to carefully tighten the
covering. Lay the control surface on a flat surface and apply
pressure over sheeted areas to thoroughly bond the
covering to the wood. Hint: Poke three or four pin holes in
the covering over the open structure in the tail surfaces. This
will allow the hot air to escape while tightening the covering.
WARNING: DO NOT OVER SHRINK THE COVERING OR
IT WILL CAUSE THE CONTROL SURFACES TO TWIST.
❏
3. Check the hinge slots of all control surfaces using a
hobby knife with a #11 blade. This will help when installing
the hinges.
ASSEMBLE THE WING
Install the Ailerons
❏ ❏
1. Test fit the right aileron to the top wing with two
6.4mm x 15mm [1/4" x 5/8"] hinges. If the hinges don't stay
centered, stick a pin through the middle of the hinges to hold
them in position while fitting the aileron to the wing.
❏ ❏
2. Remove any pins you may have inserted into the
hinges. Install the aileron so there is a very small gap
between the LE of the aileron and the wing. The gap should
be small – just enough to see light through or to slip a piece
of paper through.
❏ ❏
3. Apply three drops of thin CA to the top and bottom
of each hinge. Do not use CA accelerator. After the CA has
cured, test the hinges by pulling on the ailerons.
❏
4. Repeat steps 1-3 for the left aileron.
6