ADEMCO TI110B1 Podręcznik użytkownika - Strona 15

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System bezpieczeństwa ADEMCO TI110B1. ADEMCO TI110B1 18 stron. Gsm/pstn dual network burglar alarm system

Drukuj stronę

"transmitting" indicator light shines when the door is opened, and the host touches off

the alarm, which means you have successfully install it. But when the light signal is

green, it means that the battery for the magnetic contact has electricity shortage and the

battery should be changed.

2. Install Passive Infrared Detector

Please put the battery of the infrared detectors at the proper position and mount it at the height

of 1.8-2 m with its lens aiming at the monitored area. And then turn on the power switch for test,

and the red indicator will shine. One minute later, the detector will be in the alert state. And at

the moment, if someone motioned in the monitored zone, the red indicator shines again and

sends the intrusive signal to the alarm panel to touch off the alarm.

3. Install the host

(1) Before starting installing the alarm host, make sure that the install location should be near

the telephone line and the power socket. When it being installed on the wall, please mark

the screw hole first on the wall for correct installation.

(2) Optional accessories: wired sensor, multi-beam sensor, wired panic emergency button,

external high siren ( Installation refers to Diagram 2)

Local Telecommunication

Line

Telephone

(3) Wired Sensor Wiring: there are two wired zones (Zone 2 and Zone 10), and they are

wireless and wired compatibility. When installing the wired sensors, please use the 4-core

wire. Take off the short-circuit wire at the ends of wired zone, and connect the positive

pole and negative pole of the detector to the "+12" and "-12" of the alarm panel

respectively (Note: please note the electrodes). And connect the signal terminals of the

sensor to the counterparts of the alarm panel without distinguishing the positive and

Panic Button Wired Sensor

Siren

BUS

input

Siren

Diagram2: Wiring Diagram

Short-circuit

Zone 2 Zone 10

Emergency