ADEMCO 5816TEMP Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Nadajnik ADEMCO 5816TEMP. ADEMCO 5816TEMP 2 stron. Low temperature transmitter

Drukuj stronę

BATTERY

1. Remove the transmitter's cover (if not already off) as described in Mounting Step 3.

INSTALLATION/

2. Observe polarity and insert the battery provided into the battery holder (see Diagram 2).

REPLACEMENT

3. To replace the cover, engage the case holding posts along one edge and snap shut.

SPECIFICATIONS

Dimensions:

Battery:

The thermostat activation temperature is + 45°F ± 5°F (+4°C ± 3°C). The device resets after a temperature

TEMPERATURE

rise of about 9°F (5°C) for 5 minutes.

NOTE: The device may be reset manually using a magnet after a 4°F (2°C) rise; magnet polarity must be

properly aligned.

Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are vital to continuous

satisfactory operation of any alarm system.

The installer should assume the responsibility of developing and offering a regular maintenance program to the user as well as

acquainting the user with the proper operation and limitations of the alarm system and its component parts.

Recommendations must be included for a specific program of frequent testing (at least weekly) to insure the system's proper

operation at all times.

REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED,

FOR DETAILS ON LIMITATIONS OF THE ENTIRE ALARM SYSTEM.

Alarm Device Manufacturing Company, a Division of Pittway Corporation, and its divisions, subsidiaries and affiliates ("Seller"),

165 Eileen Way, Syosset, New York 11791, warrants its products to be in conformance with its own plans and specifications and

to be free from defects in materials and workmanship under normal use and service for 18 months from the date stamp con trol

on the product or, for products not having an ADEMCO date stamp, for 12 months from date of original purchase unless the

installation instructions or catalog sets forth a shorter period, in which case the shorter period shall apply. Seller's obligation shall

be limited to repairing or replacing, at its option, free of charge for materials or labor, any product which is proved not in

compliance with Seller's specifications or proves defective in materials or workmanship under normal use and service. Seller

shall have no obligation un der this Limited Warranty or otherwise if the product is altered or improperly repaired or serviced by

anyone other than ADEMCO factory service. For warranty service, return product transportation prepaid, to ADEMCO Factory

Service, 165 Eileen Way, Syosset, New York 11791.

THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS FOR A PARTICULAR

PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO CASE SHALL

SELLER BE LIABLE TO ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR

ANY OTHER WARRANTY, EXPRESS OR IMPLIED, OR UPON ANY OTHER BASIS OF LIABILITY WHATSOEVER, EVEN IF

THE LOSS OR DAMAGE IS CAUSED BY THE SELLER'S OWN NEGLIGENCE OR FAULT.

Seller does not represent that the products it sells may not be compromised or circumvented; that the products will prevent any

personal injury or property loss by burglary, robbery, fire or otherwise; or that the products will in all cases provide adequate

warning or pro tection. Customer understands that a properly installed and maintained alarm may only reduce the risk of a bur-

glary, robbery, fire or other events occurring without providing an alarm, but it is not insurance or a guarantee that such will not

occur or that there will be no personal injury or property loss as a result. CONSEQUENTLY, SELLER SHALL HAVE NO

LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER LOSS BASED ON A CLAIM THE PRODUCT

FAILED TO GIVE WARNING. HOWEVER, IF SELLER IS HELD LIABLE, WHETHER DIRECTLY OR INDIRECTLY, FOR ANY

LOSS OR DAMAGE ARISING UN DER THIS LIMITED WARRANTY OR OTHERWISE, REGARDLESS OF CAUSE OR ORIGIN,

SELLER'S MAXIMUM LIABILITY SHALL NOT IN ANY CASE EXCEED THE PURCHASE PRICE OF THE PRODUCT, WHICH

SHALL BE THE COMPLETE AND EXCLUSIVE REMEDY AGAINST SELLER. This warranty replaces any previous warranties

and is the only warranty made by Seller on this product. No increase or alteration, written or verbal, of the obliga tions of this

Limited Warranty is authorized.

àN7627V2kä

N7627V2 5/98

Do not bend the antenna.

Note: Replace only with: Duracell DL 123A, Sanyo CR123A, Panasonic CR123A, or ADEMCO 466.

CAUTION: Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212°F (100°C) or

incinerate. Dispose of used batteries promptly. Keep away from children.

1-9/16"W x 3-1/2"H x 1-3/16"D (40mm x 89mm x 30mm)

3V Lithium (Duracell DL123A, Panasonic CR123A, Sanyo CR123A, Varta CR123A, or

ADEMCO 466).

ADEMCO LIMITED WARRANTY

165 Eileen Way, Syosset, New York 1179

TO THE INSTALLER