DynaQuip WaterCop Classic Instrukcja obsługi i instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Przyrządy pomiarowe DynaQuip WaterCop Classic. DynaQuip WaterCop Classic 20 stron.

Drukuj stronę

need to use the manual shut-off valve to turn the water off in case of an emergency

(see Emergency Procedures on page 19 to turn water on) . When power is restored,

the WaterCop® will remain in its last known position indicated by the red or green

lights on the face of the unit .

WaterCop® Specifications

Actuator

Max . working pressure

Ambient temperature

Enclosure

Voltage

Current

Accessories

Sensor Signal Repeater

Sensors

Valve

Valve seals

Flow Data

Valve Size Cv = Gpm flow at 1 psi pressure drop

½" NPT

¾" NPT

For cold water applications

FCC Information

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules . These limits are designed to

The valve will remain closed until the unit is

manually reset on the WaterCop® panel .

After the plumbing problem is fixed, reset the

WaterCop® by pressing OPEN (green circle) on

the face of the WaterCop® . Valve will open and

green indicator will be lit . (See illustration . )

Note: If major repairs are needed to correct

the plumbing system, it is recommended that

the manual shut-off valve upstream of the

WaterCop® also be closed during the repairs .

Close the main water shut-off valve and unplug

the WaterCop® before making repairs on the

plumbing system .

Note: In case of a power failure, the WaterCop®

cannot operate . If the power is out, you will

125 psig

35° to 105° F

Polycarbonate

12 VDC plus 120 VAC adapter

0 . 8 5 Amps (Full Load)

120 VAC 47mA

3 VDC (2AA Batteries) 10mA

Full-Port, Lead-Free Brass, NPT

RTFE (Reinforced Teflon®)

1" NPT

1¼" NPT