DynaQuip WaterCop WEXT6 Instrukcja obsługi i instrukcja instalacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Systemy kontroli DynaQuip WaterCop WEXT6. DynaQuip WaterCop WEXT6 16 stron.
Drukuj stronę
Wireless WPM Hub Sensor and Accessories
Onboard Temperature
WPM: This is what is considered the "Hub" . It
Sensor – Trip Point 45°F
requires AAA Alkaline batteries (or the optional AC
Adapter) and wirelessly communicates with the Pro
Control Panel . Sensor probes and other accessories
are attached to the Hub in many different
configurations . Ambient temperature sensing is on-
board . If a temperature of 45°F or below is detected,
it will send a signal to the Control Panel .
WPSC: These are the same leak probes with 10'
of cable currently used for Pro . They wire into the
screw terminals that are accessed on the bottom of
the WPM . They have a unique hexagon shape and
they are what make single and dual leak sensors .
You can have 1 or 2 of the leak probes on each
WPM .
Standard Pro Sensor (WPSC)
Power Supply
Connection
Learn
Button
Water Probe
10'
Connection
Aux
Water Probe
Connection
Connection
WROPE6: This wireless sensor
accessory has a male plug that
6'
inserts into the female AUX jack
Rope Sensor (WROPE6)
in the Hub . It's 6' long and can be
shortened as needed . The leak
sensing is all along the braided
cord and comes with 20 clips to
secure to the floor or surface using
the included double-sided tape or screws .
WPRS095: This wireless sensor accessory will
detect high pressures and is factory set to trip
at 95 psi . It's field adjustable to trip from 50 to
120 psi . This has a male plug that inserts into
Pressure Switch (WPRS095)
the same female AUX jack on the bottom of the
Factory Set at 95 psi
WPM . To use both pressure and rope sensors,
Field Adjustable
use the WSPLIT described just below .
WSPLIT: This wireless sensor accessory will
allow an Installer to use both a rope and
Splitter (WSPLIT)
pressure, or two rope sensors, from one
WPM . It has a male plug that inserts into the
AUX jack on the bottom of the WPM and
it branches off to 2 female jacks . It's only a
few inches long .
9