High End Systems Power Cue Store Podręcznik użytkownika - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt dla DJ-ów High End Systems Power Cue Store. High End Systems Power Cue Store 19 stron.
Drukuj stronęo
Use the slider to adjust these values, then press STORE. The display shows YES,
then the new value.
Loading Scenes Into the Power Cue Store
To load scenes into the Power Cue Store:
1.
2.
3.
4.
5.
A number of attributes are stored with each scene. These are explained in the "Scene
Types" section.
The Default Scene
As described in the section "Loss of Data Key", it is possible to program the Power
Cue Store to go to scene 00 when no DMX signal is received. Scene 00 may be
loaded into memory in pass-through mode just like any other scene, and it may be
selected in pass-through mode and then output in manual mode or external control
mode. However, scene 00 may not be accessed in manual mode or external control
mode.
Selecting a Scene
Use the numeric buttons to select a scene between 00 and 63. The number of the
selected scene is shown in the display.
Select one of the following:
o
Lod 0: Blackout. Display shows —- on loss of data.
o
Lod 1: Holds the last valid signal received. Display shows —- on
loss of data.
o
Lod 2: Holds on scene 00. Display flashes 00 on loss of data.
Make sure the Power Cue Store is in pass-through mode by releasing
manual and/or external control as discussed below:
o
If the Power Cue Store is in manual control, press TAKE
CONTROL. DMX data must be present to return to pass-through
mode from manual control.
o
If the Power Cue Store is being controlled externally, release the
external control line. See "Remote Input Device" for more
information.
Output the desired scene from any DMX desk or controller.
Enter a scene number between 00 and 63 using the numeric buttons.
Press and hold the STORE button.
The display first shows Scn and then YES.
Release the STORE button.
The scene is now stored under the number you chose.
Power Cue Store
TM
TM
User Manual
Page 7