Highlander iP-1Xinline Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria do instrumentów muzycznych Highlander iP-1Xinline. Highlander iP-1Xinline 4 stron. Pickup and preamp for single cone resophonic guitar pickup and preamp for single cone resophonic guitar
Drukuj stronę
iP-1Xinline INSTALL ATION
i P- 1 Xin l i n e IN S TA L L AT I O N
Listen to the instrument, if there are no apparent problems note the height of the strings. In the event of a string buzz or other
1
Preparation
problem, deal with this first then record the new string height and continue with the installation.
Remove the strings and cover plate. Take out the resonator cone and biscuit bridge and carefully place them out of harms way.
End
Block
Connector
2
Drill Hole for Connector
Select a suitable position for the connector
and drill a 3/8" (9.5mm) hole.
Replacing the Biscuit B
Replacing the Biscuit Br i r i dge
4
Preparing the New Saddle
5
Piercing the Cone
Cone
Dome
Existing screw hole for securing the Biscuit
The information and graphics contained in this document are the property of Highlander Musical Audio Products. Copying of any kind is prohibited, except for personal use only.
Washer
Preamp
Mounting
& Screw
Clip
3
Mount the Preamp
Using the hardware provided
m o u n t t h e p r e a m p o n t h e
neck stick as indicated.
Mount the Connector.
Ve l c r o t h e c a b l e t o
the back of the guitar.
dge
The hole in the dome does not alter the tone or compromise the structural integrity of the
cone. This has been corroborated by experts at the National Reso-phonic Guitar Company.
Detach the original biscuit from the cone by removing the screw that holds them together.
Shape the new saddle to match the height, contour and string spacing of the original saddle (to preserve
the original action and feel of the instrument). Err on the side of caution, the action can be adjusted later.
Carefully pierce the 'dome' in
the top of the cone as
indicated.
Support the back of the
'dome' while piercing using a
piece of cork or rubber. Do not
press down on the cone itself.
Open the hole to 3/32"
(2.5mm) the black cable
coming from the biscuit
should pass easily through
the hole.
Please handle the cone with care. A vintage cone could be replaced
by a new cone if there are any reservations about piercing the dome.
An easy method of removing and replacing the strings and cover plate:
Release the tension on all the strings.
Place a piece of masking tape over the nut and the string retaining holes in the tailpiece.
Carefully remove the screws holding the cover plate.
Unscrew the strap nut and remove the tailpiece, cover plate and strings, carefully
placing them to one side of the guitar while leaving the strings on the tuning pegs.
Neck Stick
6
Installing the New Biscuit
Biscuit
Cable
Note: The biscuit is shown here
as transparent to reveal the
orientation of the pickup.
Saddle
Thread the cable through
the hole in the cone and
orient the biscuit as
shown.
Secure the biscuit in place
with the screw provided.
Pickup
Avoid getting adhesive on
the pickup; it will cause the
pickup to malfunction and
void the warranty.
©
Highlander Musical Audio Products 1991-2009