highwood Sequoia Professional Ridgecrest Instrukcja montażu - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Meble zewnętrzne highwood Sequoia Professional Ridgecrest. highwood Sequoia Professional Ridgecrest 16 stron. Commercial grade
Drukuj stronę
Main Beam
Spacer
24) Place the Main Beam Spacer
Between the Lower Support Beams
as Shown Above to Maintain the
Correct Beam Spacing.
E Screw
SEQUOIA
PROFESSIONAL
by
highwood
PERGOLA ASSEMBLY
Joist
25) Place the (5) Joists on Top
of the Lower Support Beams, with
the 45 Angle Facing Down, and
Centering them Over the Black
Metal Brackets On the Lower
Support Beams.
27) Secure Each Joist to the Lower Support Beams
Using (4) E Screws. Center Each Joist Over Each Black
Metal Bracket on the Lower Support Beams. This will Set
the Center-to-Center Spacing of the Joists. Place a
Screw Through the Hole in the Metal Bracket and Secure
it Into the Bottom of the Joist.
Quick Tip: Drilling a Shallow
Each Location on the Joists will Allow for Easier
Installation of the Screws.
For information on Care and Cleaning or to register your SEQUOIA
PROFESSIONAL product by highwood , please visit
www.highwood-usa.com.
Lower Support
Beam
1
" Diameter Pilot Hole Into
8
Joist Index
26) Use the Joist Index to Set the
Distance Each Joist Overhangs the
Lower Support Beam. Place the Joist
Index Against the Lower Support
Beam as Shown and Slide the Joist
Until the 45 Cut Rests Against the
Joist Index.
E Screw
CM-PGLA-1212
04.30.21
PAGE 15 of 16