Galvin Specialised Flowmatic TZ-FLOW225866 Instrukcja instalacji produktu - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji produktu dla Akcesoria Galvin Specialised Flowmatic TZ-FLOW225866. Galvin Specialised Flowmatic TZ-FLOW225866 10 stron. Wall mounted sensor tap battery operated/single temp
Drukuj stronę
INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions
and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical
supply conditions must also comply to the applicable national and/or state standards. Failing to comply with
these provisions shall void the product warranty and may affect the performance of the product.
1. Disassemble
−
Remove the M5 screw using a 2.5mm allen key (provided in the kit)
−
Pull out the inlet tail and flange from the assembly
2. Secure Inlet tail:
−
Turn off water supply.
−
Thread tape/sealant should be used. Ensure the
thread tape doesn't obscure the inlet tail opening.
Connect inlet tail to water inlet. Tighten inlet tail
–
ensuring it cannot be turned once installed.
Test:
4.
− Remove the protective sticker that covers the
sensor.
− Turn on mains water and check for leaks.
Version 2, 16
3. Assemble
−
Slide the flange and the faucet onto the inlet tail.
−
Ensure the filter stays inside the inlet tail and
does not slide out.
−
Mount the faucet body onto the inlet tail. Ensure
the sensor is aligned facing down. Secure the
body with M5 grub screw using the supplied Allen
key.
Note: Tap includes a special aerator that allows you
to adjust the water stream direction on site in order to
prevent water splashing if needed. To change the
angle of the water stream, simply move the adjustable
tilting plate by pressing it smoothly.
th
March 2021, Page 3 of 9