AFL HIBUS HCS Series Procedury instalacji - Strona 4

Przeglądaj online lub pobierz pdf Procedury instalacji dla Narzędzia AFL HIBUS HCS Series. AFL HIBUS HCS Series 4 stron. Conductor suspension clamp

Torque Clamping Bolts (item 2) on HIBUS Conductor Suspension Clamp in 5 ft-lb. increments alternating the tightening until 40 ft-lbs.

have been achieved on each.

Install HIBUS Suspension Clamp Assembly to Socket Eye with Attachment Hardware (items 7-9) as shown in Fig. 4-1.

NOTE: When an alternate bolt, nut, and cotter pin arrangement is used for attachment instead of the standard clevis pin and cotter pin,

DO NOT apply a wrench to the nut. The cotter pin should be able to be installed into the bolt when the nut is only finger tight.

Make final visual inspection on HIBUS Conductor Suspension Clamp to ensure that the assembly [groove-bushings (both ends)] and

conductor are not cocked or misaligned, but properly seated.

• 5/8" ATTACHMENT CLEVIS PIN

Fig. 4-1

• 5/8" FLAT WASHER [BOTH SIDES]

(OPTIONAL HARDWARE)

• COTTER PIN

HIBUS CONDUCTOR

SUSPENSION CLAMP

ASSEMBLY

www.AFLglobal.com or (800) 866-7385

SOCKET EYE

CONDUCTOR

HIBUS CONDUCTOR SUSPENSION CLAMP ASSEMBLY AS

INSTALLED. NOTE: SOCKET EYE—TYPE SA SHOWN FOR

INSTALLATION ONLY—CUSTOMER SUPPLIED HARDWARE.

Installation Instructions

HCS-INSP001

Specifications are subject to change without notice.