Aguilar Tone Hammer 500 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Aguilar Tone Hammer 500. Aguilar Tone Hammer 500 7 stron.
Również dla Aguilar Tone Hammer 500: Podręcznik użytkownika (8 strony)
Drukuj stronę
A. Manual Conventions
In this manual, words that appear in italics represent actual physical
controls on the Tone Hammer
B. Basic Setup
Input Voltage: 100-120/200-240 ~VAC
Mains Fuse: Internal T 6.3A/250V
Maximum power consumption: 670W
Select the proper voltage for your country's operating voltage via the
Input Voltage switch on the back of the amplifier. Select 115V for 100-120V or
230V for 220, 230 or 240V.
Connect your speaker cabinet(s) to the amplifier's speaker output using
Speakon to Speakon cables only. Use 12-gauge or larger speaker cable for proper
connections.
The amount of power this amplifier will produce varies with the
impedance rating of your cabinets.
One 8 ohm cabinet – 250 watts
Two 8 ohm cabinets – 500 watts
One 4 ohm cabinet – 500 watts
Connect the amplifier to the AC power outlet using provided power cord.
Plug in your instrument.
With the Master volume and Drive down, turn on your amplifier. Adjust as
follows:
Preamp:
1. Turn the Gain up while playing.
2. If you have a particularly high output instrument it may be necessary to
push the –10dB button in to prevent clipping of the input buffer. This
button is located next to the Input jack and when pushed in it lowers your
input signal by 10dB.
3. Turn up the Master control until you reach the volume you need.
500.
®
50/60 Hz
4.