IKEA IR8GSMXRS01 Instrukcja obsługi i konserwacji - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Lodówka IKEA IR8GSMXRS01. IKEA IR8GSMXRS01 49 stron.
Drukuj stronę
The doors are difficult to open
Explosion Hazard
Use nonflammable
cleaner.
Failure to do so can result in death, explosion, or fire.
•
Gaskets dirty or sticky? Clean gaskets and contact surfaces
with mild soap and warm water. Rinse and dry with soft cloth.
The lights do not work
•
Is a light bulb loose in the socket or burned out? See
"Changing the Light Bulb(s)."
Temperature is too warm
•
New installation?
Allow 24 hours following installation for the
refrigerator to cool completely.
•
Door(s) opened often or left open? Allows warm air to enter
refrigerator. Minimize door openings and keep doors fully
closed.
Large load of food added? Allow several hours for
refrigerator to return to normal temperature.
Controls set correctly for the surrounding conditions?
Adjust the controls a setting colder. Check temperature in
24 hours. See "Using the Control(s)."
There is interior moisture buildup
NOTE: Some moisture buildup is normal.
•
Humid room? Contributes to moisture buildup.
•
Door(s) opened often or left open? Allows humid air to enter
refrigerator. Minimize door openings and keep doors fully
closed.
The ice maker is not producing
ice or not enough
ice
•
Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
•
Kink in the water source line? A kink in the line can reduce
water flow. Straighten the water source line.
•
Ice maker turned on? Make sure wire shutoff arm or switch
(depending on model) is in the ON position.
•
New installation?
Wait 24 hours after ice maker installation
for ice production to begin. Wait 72 hours for full ice
production.
•
Large amount of ice recently removed? Allow 24 hours for
ice maker to produce more ice.
•
Ice cube jammed
in the ice maker ejector arm?
Remove ice from the ejector arm with a plastic utensil.
•
Reverse osmosis
water filtration
system
connected
to
your cold water supply? This can decrease water pressure.
See "Water Supply Requirements."
The ice cubes
are hollow or small
NOTE: This is an indication of low water pressure.
•
Water shutoff valve not fully open? Turn the water shutoff
valve fully open.
Kink in the water source line? A kink in the line can reduce
water flow. Straighten the water source line.
Reverse osmosis water filtration
system connected to
your cold water supply? This can decrease water pressure.
See "Water Supply Requirements."
Questions remain regarding water pressure?
Call a
licensed, qualified plumber.
Off-taste, odor or gray color in the ice
New plumbing
connections? New plumbing connections
can cause discolored or off-flavored ice.
Ice stored too long? Discard ice. Wash ice bin. Allow
24 hours for ice maker to make new ice.
Odor transfer from food? Use airtight, moisture proof
packaging to store food.
Are there minerals (such as sulfur) in the water? A water
filter may need to be installed to remove the minerals.
15