Align-Pilates A8-ProReformer Instrukcja montażu i instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja montażu i instrukcja obsługi dla Trenażer eliptyczny Align-Pilates A8-ProReformer. Align-Pilates A8-ProReformer 12 stron.
Drukuj stronę4. Adjusting the Rope Pull Height
The rope pull height can be adjusted by loosening the rope height adjustment knob
(Fig. 24) and then pulling the knob outwards. Slide to the desired height and ensure
the pin engages in one of the holes, then tighten the knob to prevent rattle. Please
note lowering the pulley position has the effect of shortening the ropes by up to
7.5cm.
5. Working with springs
Spring strength is indicated by the coloured anodized nuts on the RC spring bar.
Align-Pilates springs are made from nickel plated music wire for the best possible
performance and for smooth progressive resistance. Green is strong (100%) , red
is medium (75%) and blue is light (50%) - use in a combination to suit the desired
Fig.24
exercise. To get maximum life out of your springs try to vary which springs you use as
much as possible. For those seeking a lighter spring we offer an after market extra
light yellow spring (25%) which requires a supported spring cover.
To change the springs position or replace the springs, go under the reformer, unclip the shock cord and
unthread it from the spring eyelets, then uncoil the spring eyelet from the pig tail bolt and release the
velcro on the spring covers so the spring can be removed. Switch the cover to the new spring and reverse
this process. Springs must be replaced every 2 years or 3,000 hours whichever is sooner, however always
replace springs immediately if there is any sign of deformation or damage and cease using immediately.
6. Ensuring your reformer is level
It is important to check your reformer is level to ensure it runs smoothly,
particularly where the floor is not perfectly flat. Once you have positioned
your reformer in the location where you intend to use it, place a spirit level
on each runner to check it is horizontal. If it is not you can screw in or out or
more of the black reformer feet until level. Once the reformer is level then
tighten the bolt up against the bottom of the leg to secure the reformer in
this position. Please note: the distance of an exposed thread (A), as shown
in Fig. 25, should not be more than 10mm.
Fig.25
7. Video on Adjusting the A8-Pro
Visit the Align-Pilates YouTube channel to see a video on adjusting the A8-Pro reformer and a review of the
machine's features
Congratulations! You have now completed the assembly of your A8-Pro Reformer. Before first use please
read the General Usage Guide and Periodic Maintenance, Care & Safety Checks on pages 7 & 8 of this
manual as well as the safety notices on the labels attached to the frame & RC spring bar. Now would also
be a good time to make a diary note to replace your springs in two years or, within 3,000 hours, whichever
is sooner. We also recommend starting a maintenance log - a sample log can be downloaded from
https://align-pilates.com/pilates-equipment-resources/assembly-user-guides/
and you can also check for a
more to date version of this manual at this address
Further information
For assembly and other videos about the A8-Pro please visit the Align-Pilates YouTube channel
7