Align-Pilates M8-Pro Reformer Instrukcja montażu i instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja montażu i instrukcja obsługi dla Trenażer eliptyczny Align-Pilates M8-Pro Reformer. Align-Pilates M8-Pro Reformer 12 stron.

d. On the reformer, cut the cable ties, which hold the chrome foot bar selector rod in place and remove the
protective bag (Fig.3). Note: Box 2 contains the standing platform which we will return to later.
Foot bar Axles
e. Place a nylon washer on the foot bar axle (Fig.3) then take one of the aluminium foot bar swing arms and place
into position (Fig.4 & 5). Then, using an M8 12mm bolt with a single steel washer on the outside, use the allen
key and socket spanner provided to tighten on the swing arm (Fig.6). Once on, use one of the black stopper
plugs to close the hole where you inserted the socket spanner (Fig.7). Repeat on the other side.
f. You are now ready to connect the chrome foot bar selector rod (Fig. 8) using an M8 x 20mm bolt and a
dome headed M8 x 15 (no washers). Put the larger 20mm bolt part-way in first on the outside of both sides
of the reformer, and then put the smaller bolt in from the inside and fully tighten, which will prevent the bar from
rotating. Then, fully tighten the larger bolts on both sides.
g. Now attach the padded foot bar. First insert the top larger bolts finger tight (M8 x 25mm), then insert the four M8
x 20mm dome headed bolts from inside (Fig.10). Then completely tighten all 6 bolts (Fig.11)
Fig.4
Fig.6
Fig.10
Fig.3
Fig.5
Fig.7
Fig.8
Black
Blocker
Plug
Fig.11
3