Brother 885-X03 Instrukcja obsługi - Strona 15

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

CAUTION

●

Not winding the bobbin properly may

cause the thread tension to loosen, and

may break the needle.

1 Wound evenly

2 Wound poorly

Install the bobbin wound with thread.

• For more details on using the quick-set

bobbin, see page 15.

CAUTION

●

Make sure you turn off the machine

while threading. If you accidentally step

on the foot controller and the machine

starts to sew, you could be injured.

Prepare the bobbin wound properly

1

before threading the lower thread.

• See page 12 for the details about bobbin

winding.

Raise the needle by turning the

2

handwheel toward you

(counterclockwise) and raise the presser

foot lever.

Remove the bobbin cover by sliding it and

3

lift toward you.

1 Bobbin cover

1

2

1

Put the bobbin in so the thread comes out

4

in the direction shown by the arrow.

CAUTION

●

Make sure you set the bobbin so the

thread unrolls in the right direction. If

the thread unrolls in the wrong

direction, it may cause the thread

tension to be incorrect or break the

needle.

Hold the end of the thread, push the

5

bobbin down with your finger, and then

pass the thread through the slit, as shown.

• If the thread is not correctly inserted through

the tension-adjusting spring of the bobbin

case, it may cause incorrect thread tension.

1

1 Tension-adjusting spring

1

14