Garmin 011-01257-00 Instrukcja instalacji - Strona 22

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyświetlacz awioniki Garmin 011-01257-00. Garmin 011-01257-00 47 stron.

2.7

Installation Approval Considerations for Pressurized Aircraft

Antenna and cable installations on pressurized cabin aircraft require FAA approved installation design

and engineering substantiation data whenever such installations incorporate alteration (penetration) of the

cabin pressure vessel by connector holes and/or mounting arrangements.

For needed engineering support pertaining to the design and approval of such pressurized aircraft antenna

installations, it is recommended that the installer proceed according to any of the following listed

alternatives:

1. Obtain approved antenna installation design data from the aircraft manufacturer.

2. Obtain an FAA approved Supplemental Type Certificate (STC) pertaining to and valid for the

subject antenna installation.

3. Contact the FAA Aircraft Certification Office in the appropriate Region and request identification

of FAA Designated Engineering Representatives (DERs) who are authorized to prepare and

approve the required antenna installation engineering data.

4. Obtain FAA Advisory Circular AC-183C and select (and contact) a DER from the roster of

individuals identified thereunder.

5. Contact an aviation industry organization such as the Aircraft Electronics Association and request

their assistance.

2.8

Because the audio panel is a point in the aircraft where signals from many pieces of equipment are

brought together, take care to minimize effects from coupled interference and ground loops.

Coupled interference can sneak into audio system interconnecting cables when they are routed near large

AC electric fields, AC voltage sources and pulse equipment (strobes, spark plugs, magnetos, EL displays,

CRTs, etc). Interference can also couple into audio system interconnecting cables by magnetic induction

when they are routed near large AC current-carrying conductors or switched DC equipment (heaters,

solenoids, fans, autopilot servos, etc).

Ground loops are created when there is more than one path in which return currents flow or when signal

returns share the same path as large currents from other equipment. These large currents create

differences in ground potential between the various equipment operating in the aircraft. These differences

in potential can produce an additive effect on audio panel input signals.

The audio panel may "see" the desired input signal plus an unwanted component injected by ground

differentials, a common cause of alternator-related noise. This is the main reason why all audio jacks

should be isolated from ground. Terminating audio shields just at one end eliminates another potential

ground loop injection point.

Single-point grounding cannot be overstressed for the various avionics producing and processing audio

signals. Single-point, in this context, means that the various pieces of equipment share a single common

ground connection back to the airframe. Good aircraft electrical/charging system ground bonding is also

important.

The wiring diagrams and accompanying notes in this manual should be followed closely to minimize

noise effects.

Page 2-6

Revision C

GMA 1347D Installation Manual

190-00303-21