2N Helios IP Uni Instrukcja instalacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System interkomu 2N Helios IP Uni. 2N Helios IP Uni 17 stron. Door access intercom

1.5 2N



You have to know the IP address of your device to log in to the integrated web server.

By default, 2N

obtains the IP address automatically if a properly set DHCP server is available in your

LAN. If no such DHCP server is available, you can operate 2N

static IP address mode. Refer to the 2N

configuration details.

If your device remains inaccessible (you have forgotten the IP address, or the LAN

configuration has changed, for example), change the LAN settings using the buttons

on the device.

Static/Dynamic Address Setting Mode Switching

In case your 2N

the modes using one button only.



Note: The 15-times-1 sequence must be entered within 30 seconds after the first

sound signal for security reasons. The inter-digit delay may be 2s at most

The static IP address mode will be switched into the dynamic IP address mode and

vice versa upon restart.

Helios IP Uni Configuration

Helios IP Uni Use a PC equipped with any web browser to configure:

Launch your web browser (Internet Explorer, Firefox, etc.).

Enter the IP address of your intercom (http://192.168.1.100/, e.g.).

Helios IP Uni is switched into the dynamic IP address mode, i.e. it

Helios IP Uni device is equipped with 1 or 2 buttons, you can switch

Connect 2N

Helios IP Uni to the power supply (or, disconnect and reconnect

it if already connected).

Wait for the first acoustic signal

Press button 1 fifteen times.

The acoustic signal

Wait until the device is restarted automatically.

2N® Helios IP Uni Configuration

Helios IP Configuration Manual for

indicates mode switching.

Helios IP Uni in the

1.5