2N Lift1 Compact Krótki podręcznik - Strona 2

Przeglądaj online lub pobierz pdf Krótki podręcznik dla System interkomu 2N Lift1 Compact. 2N Lift1 Compact 12 stron. For lifts
Również dla 2N Lift1 Compact: Krótki podręcznik (12 strony)

Drukuj stronę

Sortiment

Part No.

919645XX

919645WBXX

Extending modules

Part No.

913646

919680E

Description

Lift1 Compact (hereinafter referred to as Lift1) is a robust, metal-encased audio unit

equipped with an ALARM button of the prescribed size by default. In buttonless versions, an

external button is connected as necessary. The audio unit is equipped with illuminated pictograms

to signal the connection state and an induction loop for deaf people. It can easily be wall mounted

without requiring precise wall cut-outs. It combines all the required lift communicator functions in

the basic version. A PSTN or alternative (PBX, GSM gateway) line is used for connection with the

control centre.

Operation

Press the ALARM button to activate connection. The "Wait" pictogram goes on immediately and

the "Connection established" symbol goes out when communication has been set up. You can use

automatic dialling of up to six pre-programmed numbers. Communication is accompanied by

factory announcements and/or user recorded lift ID messages.

Service and Operating Staff Instructions

In the Automatic Dialling with Confirmation mode – default settings:

DTMF charter:

Function

Confirm to Lift1 that the call was successful. Lift1 mutes the

currently played announcement and sends its confirmation signal.



The call goes on until the call time limit is exhausted and any of the

following commands can be used.

Mute the voice module to avoid disturbance of the operating staff



and persons in the lift.



Play the user message if stored in Lift1.

Extend the call by 30 seconds. Can be used repeatedly.

Terminate the call.

Description

Basic button version

Buttonless version

Description

Lift blocking module – blocks the lift function during

telephone line failures.

Programming tool – interconnects Lift1 with the

Service Tool on the PC for programming.