Configuring your machine for a wireless network (For HL-2270DW)
f
Wait until the Ready LED of your machine indicates Connected. The Ready LED will turn on for 5
minutes. (See the table below) This indication means the machine has successfully connected to your
WLAN access point/router. You can now use your machine in a wireless network.
If the LED indicates Connection Fail (See the table below), the machine has not successfully connected
to your WLAN access point/router or the entered PIN code is invalid. Make sure you enter the correct
PIN code, and try starting from c again. If the same message is indicated again, reset the print server
back to its factory default settings and try again. For resetting, see Reset the network settings to the
factory default on page 26.
If the LED indicates No Access Point (See the table below), the machine has detected no WLAN access
point/router on your network. Make sure you place the Brother machine as close to the WLAN access
point/router as possible with minimal obstructions, and try starting from c again. If the same message
is indicated again, reset the print server back to its factory default settings and try again. For resetting,
see Reset the network settings to the factory default on page 26.
A WLAN report will also be printed with the connection status. If there is an error code on the printed
report refer to Troubleshooting in the Quick Setup Guide.
LED indications when using the one-push wireless setting mode
LEDs
Setting WLAN
Toner
(Yellow)
Drum
(Yellow)
Error
(Orange)
Ready
(Green)
1
The LED will blink (turn on for 0.2 seconds and off for 0.1 second).
2
The LED will turn on for 5 minutes.
3
The LED will blink (turn on for 0.1 second and off for 0.1 second) for 30 seconds.
You have completed the wireless setup. To install the printer driver, please choose
"Install Printer Driver" from the CD-ROM menu.
1
2
Connected
3
Connection fail
No Access Point
3
3
20
Drukuj stronę