Brother CP-2000 Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Oprogramowanie Brother CP-2000. Brother CP-2000 33 stron. Copyboard
Również dla Brother CP-2000: Podręcznik użytkownika (19 strony), Broszura i specyfikacje (4 strony), Lista referencyjna części (18 strony)

2. Setup

After folding up the stand, the CP2000 can be carried using the handle on the back.

Be sure to use the handle to transport the

copyboard. Do not transport the unit by

carrying it by its stand, otherwise the stand

may open up and the copyboard may fall

down.

While transporting the copyboard, be careful

not to drop it, scratch it, or hit it against

anything.

Wall mounting

With the enclosed wall-mounting bar and brackets, the copyboard can easily be mounted

on a wall. In addition, by installing the printer on either a short or long edge of the

copyboard, the unit can be positioned either vertically or horizontally.

Attaching the wall-mounting bar

Follow the precautions below to mount the copyboard correctly on the wall

and reduce the risk of it falling down.

Use the enclosed anchors to attach the wall-mounting bar to plasterboard that is

at least 0.5 in. to 0.63 in. (12.7 mm to 15.9 mm) thick. When mounting the

copyboard on other types of walls, consult with a contractor first and be sure to

use the appropriate types of screws.

Make sure that there is no metal, wood, or wires behind the wall at the points

where the anchors will be installed.

Before mounting the copyboard on the wall, set it up on its stand and check that

it is operating correctly.

During installation, keep in mind that an anchor is difficult to remove once it has

been installed in the wall.

Hold the wall-mounting bar against the wall at the position where it

will be attached, making sure that it is level, and then mark the wall at

the four points where the anchors will be installed.

Be sure to attach the bar using either pair of holes A or B together with

either pair of holes C or D.

It is recommended that holes A and D be used. However, holes B and C

can be used if necessary.