Indesit WIXL 86 Instrukcja obsługi - Strona 19

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Indesit WIXL 86. Indesit WIXL 86 24 stron.

Drukuj stronę

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 18).

The temperature can be lowered, or even set to a cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.

The maximum spin speeds for each programme are as follows:

Programmes

Maximum spin speed

Cotton

800 rpm

Synthetics

800 rpm

Wool

600 rpm

Silk

The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol

The washing machine will automatically prevent you from selecting a spin speed higher than the maximum

speed for each programme.

Note: To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by

continuously rotating the drum at a speed which is slightly faster than the normal washing speed.

When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than

the set frequency.

If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.

The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:

1. press the button corresponding to the desired function, according to the table below;

2. the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the

programme set.

Function

Effect

Delays the start

of the wash by

up to 9 hours.

Delay Timer

Allows you to

perform a Pre-

wash

Pre-wash

Bleaching cycle

designed to

remove the

Stain

toughest stains.

removal

This option

reduces the

amount of

Easy iron

creasing on

fabrics, making

them easier to

iron.

Comments

Press the button repeatedly until the LED corresponding to the

desired delay is turned on.

The fifth time the button is pressed, the function will be disabled.

N.B.: Once you have pressed the Start/Reset button, the delay

can only be decreased if you wish to modify it.

It can be used on all Programmes excluded the Wool programme

and the Special Wash programme (see page 18).

This function is incompatible with the STAIN REMOVAL function.

Please remember to pour the bleach into extra compartment 4

(see page 20).

This function is incompatible with the EASY IRON function.

When this function is set, programmes 4, 5, 7 will end with the

laundry left to soak (Anti-crease) and the Rinse cycle phase

LED

will flash.

- to conclude the cycle, press the START/RESET button;

- to run the draining cycle alone, set the knob to the relative

symbol

and press the START/RESET button.

This function is incompatible with the STAIN REMOVAL function.

Enabled with

programmes:

All

1, 2, 3, 4, 5, 7

1, 2, 3, 4, 5,

Rinse cycle.

3, 4, 5, 7, 8,

9, 10, Rinse

cycle.