Indesit EDPG 67B1 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Indesit EDPG 67B1. Indesit EDPG 67B1 28 stron.

Drukuj stronę

Special wash cycles

and Options

Notes:

Optimum performance levels when using the "Daily" and "Rapid

40'" cycles can be achieved by respecting the specified number

of place settings.

To reduce consumption even further, only run the dishwasher

when it is full.

Note for Test Laboratories: for information on comparative EN

testing conditions, please send an email to the following address:

[email protected]

Wash options*

The OPTIONS may only be set, changed or reset after the

wash cycle has been selected and before the Start/Pause

button has been pressed.

Only the options whic are compatible with the type of wash

cycle set may be selected. If an option is not compatible

with the selected wash cycle

corresponding symbol flashes rapidly 3 times.

If an option is selected which is not compatible with another

(previously selected) option, it will flash 3 times and switch

off, while the most recently selected option will remain active.

To deselect an option which has been set by mistake, press

the corresponding button again.

Delayed start

It is possible to delay the start time of the wash cycle by 3,

6 or 9 hours:

1: After selecting the desired wash cycle and any other

options, press the DELAYED START button: the indicator

light will go on.

2: Select the desired delay time by pressing the Delayed Start

button repeatedly. The indicator lights for the wash phase (3

hours), drying phase (6 hours) and end phase (9 hours) will

switch on in succession.

If the Delayed Start button is pressed again, the option is

deselected and the indicator light switches off.

3. After the selection process, the countdown will begin if

the Start/Pause button is pressed. The selected delay-period

indicator light flashes and the Start/Pause button stops

flashing (fixed light.)

4. Once this time has elapsed, the DELAYED START indicator

light switches off and the wash cycle begins.

The Delayed Start function cannot be set once the wash

has been started.

Only available in selected models.

(see Table of wash cycles)

Half load

If there are not many dishes to be washed, a half load cycle

may be used in order to save water, electricity and detergent.

Select the wash cycle and press the HALF LOAD button; the

indicator light will go on.

Press the HALF LOAD button again to deselect this option.

Remember to halve the amount of detergent.

It is better to use powder detergent.

, the