Indesit I6T52/AUS Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piekarnik Indesit I6T52/AUS. Indesit I6T52/AUS 20 stron.

Drukuj stronę

1. Control Panel

HOOD

600

Min.

mm.

Fig. A

Gas connection

This appliance is suitable for use with either a

ﬂ exible connection or rigid copper connection.

Check The Gas Type

WARNING: Before installation, check that the gas

type (natural gas or LPG/Propane) of the cooker is

suitable for the gas type available to the installation. It

is extremely dangerous to use the wrong gas type with

any appliance, as fire or serious injury can result.

This cooker is supplied from the factory already set for

HOT PARTS

It is recommended that an isolating valve and union

be fitted, to enable simple disconnection for servicing.

These are to be in an accessible location.

! Make sure the supply pressure conforms with the

values shown in the table entitled "Caracteristics of the

burners and nozzles".

When the cooker is installed between cabinets

(recessed), the gas connection must be effected by

an approved flexible hose with bayonet fitting (BS

669 Current Edition). The gas inlet for the cookers is a

threaded G 1/2 gas female fitting.

Connecting the gas supply

If a flexible hose is used, it should be as short as

Fig. B

Natural Gas. To convert

the cooker to LPG (or

back to Natural Gas

from LPG), follow the

directions later in this

section.

Fit regulator supplied

for Natural Gas (if

applicable) at rear of

appliance, and as close

as practicable to the

appliance.

possible with a maximum length of 1.5 metres;

• The flexible connection must be approved to class B

or D of AS/NZS1869 as a minimum.

• it should not be bent, kinked or compressed;

• it should not be in contact with the rear wall of the

appliance or in any case with parts which may reach

a temperature of 50°C;

• it should not come into contact with pointed parts or

sharp corners;

• it should not be subject to any pulling or twisting

forces;

• it should be easy to inspect along its entire length in

order to be able to check its condition.

• The supply connection point must be accessible

with the appliance installed.

• The inner diameters of the pipe are as follows:

8 mm for LPG;

13 mm for Natural Gas.

Upon completion of installation, check the gas circuit,

the internal connections and the taps for leaks using

a soapy solution (never a flame). Also check that the

connecting pipe cannot come into contact with moving

parts which could damage or crush it. Make sure that

the natural gas pipe is adequate for a sufficient supply

to the appliance when all the burners are lit.

Duplicate Data Plate

Where the data plate is obscured by cabinetry when

the cooker is in the installed position, place a duplicate

data plate on a surface of the cabinetry adjacent to the

cooker.

Electrial connection

Power supply voltage and frequency: 220-240V a.c.

50/60 Hz.

! The supply cable must be positioned so that it never

reaches at any point a temperature 50°C higher than

the room temperature. The cable must be routed away

from the rear vents. Should you require it, you may

use a longer cable, however, you must ensure that the

cable supplied with the appliance is replaced by one

of the same specifications in accordance with current

standards and legislation.

Your appliance is supplied with a 13 amp fused

plug that can be plugged into a 13 amp socket for

immediate use. Before using the appliance please read

the instructions below.

WARNING - THIS APPLIANCE MUST BE EARTHED.

THE FOLLOWING OPERATIONS SHOULD BE

CARRIED OUT BY A QUALIFIED ELECTRICIAN.