Indesit K6G52.U Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piekarnik Indesit K6G52.U. Indesit K6G52.U 28 stron. Cooker and oven
Również dla Indesit K6G52.U: Instrukcja instalacji i użytkowania (32 strony)

Drukuj stronę

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

! Never use steam cleaners or pressure cleaners on

the appliance.

• The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse well and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The hob grids, burner caps, flame spreader rings

and burners may be removed to make cleaning

easier; wash them in hot water and non-abrasive

detergent, making sure all burnt-on residue is

removed before drying them thoroughly.

• For hobs with electronic ignition, the terminal part

of the electronic lighting devices should be

cleaned frequently and the gas outlet holes

should be checked for blockages.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

•

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product,

then dry thoroughly with a soft cloth. Do not use

rough abrasive material or sharp metal scrapers

as these could scratch the surface and cause the

glass to crack.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

Inspecting the oven seals

Check the door seals around the oven regularly. If

the seals are damaged, please contact your nearest

Authorised After-sales Service Centre. We

recommend that the oven is not used until the seals

have been replaced.

Replacing the oven light bulb

1. After disconnecting the oven from the electricity

mains, remove the glass lid covering the lamp

socket ( see figure ).

2. Remove the light bulb and

replace it with a similar one:

voltage 230 V, wattage 25 W, cap

E 14.

3. Replace the lid and reconnect

the oven to the electricity supply.

Gas tap maintenance

Over time, the taps may become jammed or difficult

to turn. If this occurs, the tap must be replaced.

! This procedure must be performed by a

qualified technician who has been authorised by

the manufacturer.

Assistance

Please have the following information to hand:

• The appliance model (Mod.).

• The serial number (S/N).

This information can be found on the data plate

located on the appliance and/or on the packaging.

Only available in certain models.