Indesit IDCE 845 A Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Suszarka Indesit IDCE 845 A. Indesit IDCE 845 A 20 stron. Indesit clothes dryer user manual
Również dla Indesit IDCE 845 A: Instrukcja obsługi (20 strony), Instrukcja obsługi (20 strony)

Drukuj stronę

If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical

Assistance Centre

(see Assistance).

• The plug has not been inserted far enough into the socket to make contact.

• There has been a power cut.

• The fuse has blown. Try connecting another appliance to the same socket.

• If an extension cord is used, try connecting the dryer plug directly into the socket.

• The door has not been closed properly.

• The programme has not been set correctly (see How to carry out a drying cycle).

• The

START/PAUSE

button has not been pressed (see How to carry out a drying cycle).

• A delayed start time has been set (see Programmes and options).

• The

START/PAUSE

button has been pressed; a short delay follows before the

dryer starts running. Wait for the drying cycle to start; do not press the

PAUSE

button otherwise the dryer switches to the pause mode and the drying

cycle will not start.

• The filter has not been cleaned (see Maintenance).

• The water container must be emptied? The "Empty water container" indicator light

flashes and the message appears

• The condenser needs to be cleaned (see Maintenance).

• The heat setting is not suited to the type of fabric to be dried (see Programmes and

options).

• An incorrect drying time was selected for the type of load (see Laundry).

• The items are too wet (see Laundry).

• The air intake grille are clogged up (see "Installation" and "Care and Maintenance").

• The dryer is overloaded (see Laundry).

• The water container was probably not emptied before starting the programme. Do

not wait for the signal for emptying the water container, but always check and

empty it before starting a new drying programme (see Description of the tumble

dryer).

• It is normal: the "Empty water container" indicator light flashes when the water

container is full. If the indicator light is on but is not flashing, it is just a reminder to

empty the container (see Description of the tumble dryer).

For safety reasons, the dryer programmes last a maximum of 4 hours. If an

automatic programme has not detected the final dampness level required in this

interval, the dryer completes the programme and stops. Check the above points

and repeat the programme; if the items are still damp, contact the Technical

Assistance Centre (see Assistance).

• If the display visualises F10 or F15, switch the appliance off and unplug it, then clean

the filter and the condenser (see Maintenance). Reinsert the plug, switch the

appliance on and start another programme. If the display still visualises F10 or F15,

contact the Technical Assistance Centre (see Assistance). If the display still

visualises other numbers, mark the code and contact the Technical Assistance

Centre (see Assistance).

• The appliance is in "Demo" mode. Press the ON/OFF and

and keep them pressed for 3 seconds. The display visualises

seconds, then the dryer starts functioning normally.

• The remaining time is constantly monitored during the drying cycle and is updated

to show the best forecast. It is normal for the displayed time to increase during the

cycle.

• This is normal, especially if the dryer has not been used for a long time. If the noise

persists during the entire cycle, contact the Technical Assistance Centre.

H2O

(see Maintenance).

START/PAUSE

dOn

START/

buttons

for 3