A-Neuvideo ANI-QUAD Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przełącznik matrycowy A-Neuvideo ANI-QUAD. A-Neuvideo ANI-QUAD 19 stron. 4x4 hdmi video wall processer & matrix switch

Drukuj stronę
OSD OPERATION
Main Menu
BEZEL CORRECTION
(*7)
RECALL / SAVE
(*8)
ETHERNET
OTHERS
FACTORY DEFAULT EXIT
INFORMATION
(*12)
EXIT
Note:
*1 Picture: In Matrix mode, four pictures adjust simultaneously. In Dual/Video Wall mode, each picture can adjust individually and support individual last
memory feature.
*2 Output: In Video Wall mode and Dual Mode, Output resolution 1080i@50Hz and 1080i@60Hz are not supported.
*3 AUDIO EDID: Embedded input audio EDID contents, LPCM 2CH = LPCM 2CH LPCM 6CH = LPCM 2CH/ 6CH LPCM 8CH = LPCM 2HC/ 6CH/ 8CH
BITSTREAM = LPCM 2CH, AC3, DTS HD = LPCM 2CH/ 6CH/ 8CH, AC3, DTS, Dolby Digital Plus, DTS-HD
*4 TIMEOUT: OFF means MENU and INFO will show continuously on the screen
*5 HDCP INPUT: ACCEPT: Support HDCP source, this is default setting. NOT ACCEPT: Not support HDCP source.
For example: Apply source.
*6 HDCP OUTPUT: FOLLOW INPUT: If source with HDCP the output will support HDCP. If input source without HDCP the output will not support HDCP.
When in Dual mode, one of each side (Left or Right) support HDCP, the output will support HDCP. ALWAYS ON: All the displays need to support HDCP, to
avoid switching source from non-HDCP to HDCP, or fl ashing image or no image.
*7 BEZEL CORRECTION: Only supported in Video Wall mode, after adjustment the system will support last memory function.
*8 SAVE/RECALL: To SAVE/RECALL input/output setting, the system support last memory function to save all settings.
*9 Ethernet RE-LINK: After the setup, need to RE-LINK the system and re-connect the system again.
*10 Ethernet TIMEOUT: Select OFF to end the time out function or when telnet is under idol without sending commands within the time out setting the
telnet system will be terminated.
*11 IR ADDRESS: This setting is to match the IR remote control dip switch. Refer to section x.x for remote control settings.
*12 INFORMATION: To show Input/Output/Audio/Mode/Firmware information.
OSD MENU
Sub Menu
CORRECTION
H CORRECTION
V CORRECTION
EXIT
RECALL
SAVE
EXIT
IP MODE
STATIC SET
BYTE1
BYTE2
BYTE3
BYTE4
RE-LINK(*9)
TIMEOUT (Min.)(*10)
EXIT
IR ADDRESS(*11)
EXIT
YES, NO
EXIT
IN/OUT RESOLUTION,
SOURCE HDCP/AUDIO,
OUT MODE, FIRMWARE
VER
EXIT
Adjustments
ON, OFF
0 ~ by output resolution
0 ~ by output resolution
CANCEL, FAV.1~ 4
CANCEL, FAV.1~ 4
DHCP, STATIC
IP, MASK, GATE
5~60, OFF
0 ~ 3
11
Default
OFF
0
0
CANCEL
CANCEL
DHCP
IP
192
168
5
155
10
0
NO