Kohler 20007A-PNE-NA Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Produkt hydrauliczny Kohler 20007A-PNE-NA. Kohler 20007A-PNE-NA 10 stron. Pneumatic in-wall tank with frame short height
Drukuj stronę4. Fit the waste pipe and the flush pipe covers.
S-trap installation
1. Loosen the screw on waste pipe support
bracket if required.
2. Insert S-trap waste pipe into the waste pipe
support bracket.
3. Adjust the pipe position and tighten the
waste pipe support bracket screw to secure
the discharge elbow.
4. Insert the S-trap waste pipe lower end into
discharge port.
5. Fit the waste pipe and the flush pipe covers.
Connecting water inlet hose
● Ensure the water tank internal shut off valve is OFF.
Note: Turn anti-clockwise to close and clockwise to open.
● Connect the water inlet hose (not supplied) to the tank
water inlet.
1310920-A02-A
Flush pipe
cover
Waste pipe cover
S-trap waste pipe
S-trap
waste pipe
Waste pipe
support bracket
Flush pipe
Waste pipe cover
Tank water inlet
Water inlet
hose
-4-
Waste connector
Waste pipe
support bracket
Tank frame
Bottom of the
S-trap waste pipe
Discharge port
k
Tan
Frame
Flush pipe cover