A-Neuvideo HD-22 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przełącznik matrycowy A-Neuvideo HD-22. A-Neuvideo HD-22 12 stron. 2x2 hdmi matrix switcher
Drukuj stronęMORE STUFF FOR HD-22
Note: Turning the unit System Power Off over RS-232 will distinguish the LED display leaving only the Power Switch LED
on. The Video and Audio outputs will also mute. While the unit is turned off by RS-232 it will continue to accept and
act upon switching commands. For example, if the unit is in the off mode (via RS-232) and you send a command
to switch an input to an output, that route will complete and the video and audio will now appear on that channel only.
The front panel LED for that particular output will also show the input selected (for that single output channel only). The
remaining LED's will remain off and video and audio outputs muted. The unit will still return status and change messages
in response to commands sent while in Power Off state. A hard reset command (SBALLRST) will return the unit to
normal operation and also unlock the front panel
Power Off mode.
- Put system into Standby (Soft Power Off)
SBSYSMOF
- Bring unit out of Standby (Soft Power On)
SBSYSMON
Unit will respond with
- Unit is in Standby
SBALOFAK
- Unit is no longer in Standby
SBALONAK
Example: Put Unit in Standby (Soft Power)
-Send
SBSYSMOF
-Rcvd
SBALOFAK
FRONT PANEL LOCK
Note: Hard resetting the unit will unlock the Front Panel controls.
- When front panel is locked, changes can only be made by RS-232
SBSYSMLK
- Front Panel Unlock
SBSYSMUK
Unit will respond with
- Front Panel has been Locked
SBSYSLOK
- Front Panel has been Unlocked
SBSYSULK
Example: Lock Front Panel Buttons
-Send
SBSYSMLK
-Rcvd
SBSYSLOK
UNIT RESET
- Reset every output to Input 1
SBALLRST
Unit will respond with
- Unit has reset each Output to Input 1
SBRSTACK
Example: Reset all outputs to Input 1
-Send
SBALLRST
-Rcvd
SBRSTACK
RS-232 SERIAL COMMANDS
7