AEG LAVATHERM T56600 Informacje o użytkowniku - Strona 22
Przeglądaj online lub pobierz pdf Informacje o użytkowniku dla Suszarka AEG LAVATHERM T56600. AEG LAVATHERM T56600 33 stron. Condensation dryer
Drukuj stronę125983250.qxp
2006-03-21
Drying results
unsatisfactory.
Loading door does not
close.
When pressing a button,
the corresponding
button flashes several
times.
Drum light does not
work.
Programme inactive,
EMPTY WATER (RESERVOIR)
display illuminated.
Drying cycle ends
shortly after programme
starts. END
(EINDE) display illuminated.
22
11:11
Page 22
Problem
Possible cause
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged
with lint.
Incorrect volume of laundry.
Ventilation slots in base
area covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at
installation
site differs from
standard setting of machi-
ne.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Programme selector in OFF
(UIT) position.
Defective light bulb.
Condensate tank is full.
Not enough washing loaded
or washing loaded is too
dry for selected programme.
Remedy
Select a different program-
me the next time you dry
(see "Overview of program-
mes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended loa-
ding volumes.
Uncover ventilation slots in
base area.
Clean inside surface of
drum and drum ribs.
Re-programme standard set-
ting for degree of drying
(see 'Programming options'
section).
Install fine strainer and/or
snap large mesh filter into
place.
Turn the programme knob
to OFF (UIT). Set the pro-
gramme again.
Turn programme selector to
LIGHT (VERLICHTING) or to
any programme.
Replace light bulb (see next
section).
Empty condensate tank,
then start programme with
START/PAUSE (START/PAUZE)
button.
Select time programme or
higher drying level (e.g.
INTENSIVE DRY - INTENSIEF-
DROOG instead of STORAGE
DRY - KAST-DROOG).