Kohler Symbio K-1335-H Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Armatura łazienkowa Kohler Symbio K-1335-H. Kohler Symbio K-1335-H 32 stron. Bath whirlpool

Drukuj stronę

Nail 1/4"

(6mm) thick

furring strips

to the back

studs

Stud

Use #6 large-head

galvanized nails to

secure the back

nailing-in flange to

the studs

6. Secure the Whirlpool to the Stud Framing

- Insert the drain tailpiece into the trap. Make sure the whirlpool is level and resting on all support feet.

NOTE: Do not secure the side (vertical) nailing in flange at this time.

- Drill a small pilot hole through the back nailing in flange at each stud. Add shims between the back nailing in

flange and the studs as needed to eliminate gaps.

- Nail 1/4" (6mm) thick furring strips to the back studs to shim out to the edge of the nailing in flange.

- Use #6 large head galvanized nails to secure the back nailing in flange to the studs.

7. Cut the Pump Banding Straps

IMPORTANT! This step is necessary to make your Kohler whirlpool operate more quietly.

- Use tin snips to cut the two pump banding straps from the whirlpool pump. When the banding straps are cut, the

pump base and pump will drop about 1/2" (1.3cm) until they rest on the subfloor. If the pump drops more than

1/2" (1.3cm), shim under the pump base so water will drain from the pump and the suction line when the

whirlpool is drained.

NOTE: Do not raise the pump higher than it was before you cut the pump banding straps. If the pump is raised

too high, it will not prime properly.

- To minimize whirlpool noise and vibration, be sure the pump is not in direct contact with the shipping bracket

after the pump banding straps are cut. The pump base contains rubber isolation feet to reduce pump noise.

1012312-2-

Drill a small hole

through the back

nailing-in flange

at each stud

Drainage

Suction Line

Leave the

shipping bracket

attached to the

whirlpool

Pump

Cut the

pump

banding

straps

Pump Base

Shim the pump base if

necessary so water will

drain properly from the

pump and suction line

Kohler Co.