Kohler VINTAGE K-700 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wanny Kohler VINTAGE K-700. Kohler VINTAGE K-700 9 stron. Roughing-in guide
Również dla Kohler VINTAGE K-700: Instrukcja instalacji (21 strony), Instrukcja uruchomienia (4 strony), Instrukcja instalacji i obsługi (25 strony), Podręcznik (4 strony)

5. SITE PREPARATION

A. OLD BATH REMOVAL

Disconnect the drain at the trap. Remove the old wall

material. Slip boards under the old bath feet to

protect the floor, and slide the old bath out of the

recess as illustrated.

B. SUBFLOOR PREPARATION

Make sure the flooring offers adequate support for your

whirlpool, and verify that the subfloor is flat and level.

C. STUD POCKET PREPARATION

Construct a recess designed for your particular

installation. Framing is of 2x4 construction. Make sure

you allow for access to the pump in the event the unit

requires service. When constructing the framing, allow

for the thickness of sub and finished wall materials.

If an apron wall without a ledge is desired, the finished

apron wall surface must be 1/16" (2mm) under the bath

rim.

The whirlpool can be installed in a corner. Recess or

sunken installations are also possible. Steps 1. through 3.

below illustrate suggested stud construction.

Modifications may be needed for other types of

construction.

NOTICE: Do not install the wood rim to units used

in sunken installations.

Corner

Installation: The suggested stud

construction is illustrated.

Kohler Co., Kohler WI U.S.A.

Old Bath

69" (175.3cm)

19" R.

Vintage Cutout

Floor

Protection

Boards

40"

(101.6cm)

110050-2-